On Tue, Mar 13, 2012 at 12:44:08PM -0700, Rhyland Klein wrote:

> This change adds the logic to support using the jack detect mechanism built
> in to the codec to detect both when a jack was inserted and what type of
> jack is present.

This looks mostly good, a few things below.

> @@ -51,6 +52,9 @@ struct max98095_priv {
>  	u8 lin_state;
>  	unsigned int mic1pre;
>  	unsigned int mic2pre;
> +	int irq;

You can just get the irq from the I2C device.

> +	if (max98095->headphone_jack == max98095->mic_jack)
> +		snd_soc_jack_report(max98095->headphone_jack,
> +					hp_report | mic_report,
> +					SND_JACK_HEADSET);
> +	else {

Braces on both sides of the if for clarity.

> +static irqreturn_t max98095_jack_handler(int irq, void *data)
> +{
> +	struct snd_soc_codec *codec = data;
> +	int ret;
> +
> +	ret = max98095_report_jack(codec);
> +
> +	return ret ? IRQ_NONE : IRQ_HANDLED;

There is no point in having a separate function here, this function has
no contents.  Just inline it.  Please also avoid the use of the ternery
operator.

> +	/* configure jack detection: slew is calculated as 4 * (delay + 1)
> +	 * The default is 24 (0x18) to get 100ms delay.
> +	 */
> +	ret = snd_soc_write(codec, M98095_08E_JACK_DC_SLEW,
> +				M98095_DEFAULT_SLEW_DELAY);
> +	if (ret < 0) {
> +		dev_err(codec->dev, "Failed to cfg auto detect %d\n", ret);
> +		return ret;
> +	}

Platform data?

> +	enable_irq(max98095->irq);

You shouldn't be fiddling around with enable_irq() and disable_irq().
Why are you doing this?