Same code. Use the generic version. Signed-off-by: Thomas Gleixner Acked-by: Jesper Nilsson --- arch/cris/Kconfig | 1 + arch/cris/kernel/process.c | 28 ---------------------------- 2 files changed, 1 insertion(+), 28 deletions(-) Index: tip/arch/cris/Kconfig =================================================================== --- tip.orig/arch/cris/Kconfig +++ tip/arch/cris/Kconfig @@ -50,6 +50,7 @@ config CRIS select GENERIC_IRQ_SHOW select GENERIC_IOMAP select GENERIC_SMP_IDLE_THREAD if ETRAX_ARCH_V32 + select HAVE_GENERIC_INIT_TASK config HZ int Index: tip/arch/cris/kernel/process.c =================================================================== --- tip.orig/arch/cris/kernel/process.c +++ tip/arch/cris/kernel/process.c @@ -29,34 +29,6 @@ //#define DEBUG /* - * Initial task structure. Make this a per-architecture thing, - * because different architectures tend to have different - * alignment requirements and potentially different initial - * setup. - */ - -static struct signal_struct init_signals = INIT_SIGNALS(init_signals); -static struct sighand_struct init_sighand = INIT_SIGHAND(init_sighand); -/* - * Initial thread structure. - * - * We need to make sure that this is 8192-byte aligned due to the - * way process stacks are handled. This is done by having a special - * "init_task" linker map entry.. - */ -union thread_union init_thread_union __init_task_data = - { INIT_THREAD_INFO(init_task) }; - -/* - * Initial task structure. - * - * All other task structs will be allocated on slabs in fork.c - */ -struct task_struct init_task = INIT_TASK(init_task); - -EXPORT_SYMBOL(init_task); - -/* * The hlt_counter, disable_hlt and enable_hlt is just here as a hook if * there would ever be a halt sequence (for power save when idle) with * some largish delay when halting or resuming *and* a driver that can't