On Mon, Nov 05, 2012 at 12:22:55PM +0100, Michal Simek wrote: > 2012/10/29 Josh Cartwright : > > Suggested cleanup by Arnd Bergmann. Move the ttc timer.c code to > > drivers/clocksource, and out of the mach-zynq directory. > > > > The common.h (which only held the timer declaration) was renamed to > > xilinx_ttc.h and moved into include/linux. > > > > Signed-off-by: Josh Cartwright > > Cc: Arnd Bergmann > > --- > > arch/arm/mach-zynq/Makefile | 2 +- > > arch/arm/mach-zynq/common.c | 2 +- > > drivers/clocksource/Makefile | 1 + > > arch/arm/mach-zynq/timer.c => drivers/clocksource/xilinx_ttc.c | 1 - > > arch/arm/mach-zynq/common.h => include/linux/xilinx_ttc.h | 4 ++-- > > 5 files changed, 5 insertions(+), 5 deletions(-) > > rename arch/arm/mach-zynq/timer.c => drivers/clocksource/xilinx_ttc.c (99%) > > rename arch/arm/mach-zynq/common.h => include/linux/xilinx_ttc.h (91%) > > Not going to apply this patch till there is clean way how to move all > drivers there. Especially I don't like to add xilinx_ttc.h to > include/linux folder. Okay; I think it's best to defer the moving of the ttc driver from this patchset. It is not a dependency of the clk driver support stuff. If you agree, I can spin up a v2 of the patchset w/o this change, and without the serial CONFIG_OF stuff. Should v2 contain the patches you've already pulled into testing? I'll give Rob's irqchip-like suggestion a spin and see how that works out in parallel. Thanks, Josh