From mboxrd@z Thu Jan 1 00:00:00 1970 From: Tom Rini Date: Fri, 21 Mar 2014 14:48:42 -0400 Subject: [U-Boot] [PATCH 1/6] add README.distro file In-Reply-To: <1395353581-5839-2-git-send-email-dennis@ausil.us> References: <1392659798-1665-1-git-send-email-dennis@ausil.us> <1395353581-5839-1-git-send-email-dennis@ausil.us> <1395353581-5839-2-git-send-email-dennis@ausil.us> Message-ID: <20140321184842.GN16360@bill-the-cat> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On Thu, Mar 20, 2014 at 05:12:56PM -0500, Dennis Gilmore wrote: > Add documentation on how to setup a system to use the generic distro > configs and boot commands. This spells out what is needed to make a > system conformant, but does not limit the board to only the defaults. > > Signed-off-by: Dennis Gilmore [snip] > +suggested mapping: > +For suggestions on memory locations for arm systems you must follow the > +guidelines specified in Documentation/arm/Booting in the Linux kernel tree. > +For other architectures you must follow the guidelines for the architecture. Can you add something about what this means? ie below base+128MB for kernel, because of this if possible base+128MB for fdt, fdt+512KB for ramdisk. And mention bootm_size to limit the relocation pool as well. Thanks! -- Tom -------------- next part -------------- A non-text attachment was scrubbed... Name: not available Type: application/pgp-signature Size: 836 bytes Desc: Digital signature URL: