Hi,

(side note)

On Wed, Jun 18, 2014 at 06:19:23PM -0500, Felipe Balbi wrote:
> > >>>+		interrupt-controller;
> > >>>+		#interrupt-cells = <2>;
> > >>>+
> > >>>+		dcdc1: regulator-dcdc1 {
> > >>>+			compatible = "ti,tps65218-dcdc1";
> > >>>+			/* VDD_CORE limits min of OPP50 and max of OPP100 */
> > >>>+			regulator-name = "vdd_core";
> > >>>+			regulator-min-microvolt = <912000>;
> > >>>+			regulator-max-microvolt = <1144000>;
> > >>>+			regulator-boot-on;
> > >>>+			regulator-always-on;
> > >>>+		};
> > >>>+
> > >>>+		dcdc2: regulator-dcdc2 {
> > >>>+			compatible = "ti,tps65218-dcdc2";
> > >>>+			/* VDD_MPU limits min of OPP50 and max of OPP_NITRO */
> > >>>+			regulator-name = "vdd_mpu";
> > >>>+			regulator-min-microvolt = <912000>;
> > >>>+			regulator-max-microvolt = <1378000>;
> > >>>+			regulator-boot-on;
> > >>>+			regulator-always-on;
> > >>>+		};
> > >>>+
> > >>>+		dcdc3: regulator-dcdc3 {
> > >>>+			compatible = "ti,tps65218-dcdc3";
> > >>>+			regulator-name = "vdds_ddr";
> > >>no voltage ?
> > >
> > >has no users in kernel. Also, it comes out with default, and correct,
> > >voltage.
> > 
> > Device tree is description of hardware, not just who uses what in OS
> > of interest.
> 
> then we should start "fixing" every single DTS in the kernel because I'm
> sure even LEDs and keypads are tied to some sort of supply, as is the
> case with this board. No driver will use it though.
> 
> Also, I couldn't find anywhere which voltage is dcdc3 outputing and
> there's no shunt anywhere (other than a 0 ohm resistor) to measure
> voltage. So I kinda have my hands tied here.
> 
> (goes review schematics)
> 
> actually there's 0.05 ohm sense resistor. Hopefully it's easy to access.

1.35v

-- 
balbi