Hi,

On Mon, Mar 16, 2015 at 08:29:39AM -0700, Tony Lindgren wrote:
> * Arnd Bergmann <arnd@arndb.de> [150315 05:10]:
> > On Sunday 15 March 2015 10:50:42 Eliad Peller wrote:
> > > yeah, i missed it :/
> > > 
> > > looks like there's no platform that defines platform data for it.
> > > i'll replace the dev_get_platdata() with a function that only parses
> > > the clock-frequency properties (the irq is taken in this case from the
> > > spi_device).
> > > (or maybe i should just drop it, as no one actually uses it?)
> > 
> > I don't think we should drop the driver, but dropping the platform_data
> > support sounds reasonable. New users of this driver should all be using
> > DT, and if there is a good reason to use platform_data, it's easily
> > put back.
> 
> Well we have n8x0 and n900 using the spi driver. For those, n8x0 boot
> all in dts mode, but n900 still also boots in legacy mode. It seems the
> board-rx51-peripherals.c only passes the power_gpio though, so that
> should be easy to keep around.
> 
> We should keep things still working for n900 in legacy mode until the
> pending regressions with device tree based booting have been cleared
> for at least one merge cycle. I believe the last pending issues is the
> support for ATAG_REVISION in device tree mode as posted by Pali.

mh by migrating to newer gpiod interface platform data is no longer
needed (instead the boardfile would need a gpiod_lookup_table). That
way all of the dirty code is in the board file and will be removed
once the time comes. See for example rx51_fmtx_gpios_table.

Note: This is independent of wl12xx changes, since N900 uses wl1251.

-- Sebastian