From mboxrd@z Thu Jan 1 00:00:00 1970 From: Tom Rini Date: Thu, 26 Mar 2015 10:07:55 -0400 Subject: [U-Boot] [PATCH 0/4] Add support for stm32f429-discovery board In-Reply-To: <55140DE5.5080504@wp.pl> References: <1425210282-7887-1-git-send-email-rev13@wp.pl> <20150325165830.GU32541@bill-the-cat> <55140DE5.5080504@wp.pl> Message-ID: <20150326140755.GA32541@bill-the-cat> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On Thu, Mar 26, 2015 at 02:47:17PM +0100, Kamil Lulko wrote: > On 25/03/15 17:58, Tom Rini wrote: > >On Wed, Mar 25, 2015 at 01:07:47PM +0900, Chanwoo Choi wrote: > >>Hi Kamil, > >> > >>I tested this patch-set in STM32 Discovery board. After applied this > >>patch-set on latest u-boot, I could not see the normal u-boot log. I > >>saw broken console log. I used the USART1 port (pa9, pa10 gpio pin). > >> > >>Could you give me a tip to resolve this issue? > >I bet this needs changes similar to b81bdf6 as that was a similar > >problem I believe. In short, DM needs to be enabled now. > > > >>Best Regards, > >>Chanwoo Choi > >> > >>2015? 3? 1? ???, Kamil Lulko?? ??? ???: > > I have tested this patch set again with 2015.04-rc4-gf643d92 and > serial works without any problems. > > Chanwoo, you mention STM32 Discovery board - this patch set supports > only STM32F429 Discovery (it should work on SDRAM-less boards but > not without modifications). Other than that the only thing I can > think of is configuration of the UART<>USB converter. > > Tom, does this mean changes are required for this patchset to be > accepted? I have more things queued up (like moving some of SDRAM > configuration bits out of the board code or LCD display support) but > I would prefer to have some kind of assurance that this will not go > into /dev/null eventually :) Right now the patches don't apply cleanly due to 68145d4c but it's an easy enough fixup by hand. I plan to apply the current series after the 2015.04 release. If you want to start posting stuff that depends on the initial series being applied that's fine. Thanks! -- Tom -------------- next part -------------- A non-text attachment was scrubbed... Name: signature.asc Type: application/pgp-signature Size: 836 bytes Desc: Digital signature URL: