From mboxrd@z Thu Jan  1 00:00:00 1970
From: Marek Vasut <marex@denx.de>
Date: Thu, 17 Dec 2015 17:17:42 +0100
Subject: [U-Boot] [PATCH 1/2] arm: imx6: Add DDR3 calibration code for
	MX6 Q/D/DL
In-Reply-To: <CAJ+vNU3Cy1x1af=0NfG_E8r8ZhPVTayJooeJo=7JUvw=vxJ-9Q@mail.gmail.com>
References: <1450276807-8960-1-git-send-email-marex@denx.de>
 <201512171640.19455.marex@denx.de>
 <CAJ+vNU3Cy1x1af=0NfG_E8r8ZhPVTayJooeJo=7JUvw=vxJ-9Q@mail.gmail.com>
Message-ID: <201512171717.43096.marex@denx.de>
List-Id: <u-boot.lists.denx.de>
MIME-Version: 1.0
Content-Type: text/plain; charset="us-ascii"
Content-Transfer-Encoding: 7bit
To: u-boot@lists.denx.de

On Thursday, December 17, 2015 at 05:15:46 PM, Tim Harvey wrote:
> On Thu, Dec 17, 2015 at 7:40 AM, Marek Vasut <marex@denx.de> wrote:
> > On Thursday, December 17, 2015 at 04:36:20 PM, Tim Harvey wrote:
> >> On Wed, Dec 16, 2015 at 6:40 AM, Marek Vasut <marex@denx.de> wrote:
> >> > Add DDR3 calibration code for i.MX6Q, i.MX6D and i.MX6DL. This code
> >> > fine-tunes the behavior of the MMDC controller in order to improve
> >> > the signal integrity and memory stability.
> >> > 
> >> > Signed-off-by: Marek Vasut <marex@denx.de>
> >> > Cc: Stefano Babic <sbabic@denx.de>
> >> 
> >> Marek,
> >> 
> >> This is great - this would be a great addition to U-Boot IMX6 SPL.
> >> 
> >> You must have forgotten to post a dependent patch that adds some of
> >> the registers to mmdc_p_regs. If you can post that I can run this
> >> through some testing.
> > 
> > What exactly is missing please ? I am using this on Novena for a while
> > without issues.
> 
> sorry my bad... forgot I was on an old branch. All is good.
> 
> I will run some boards with this through some stress testing and review.

Whew! OKi, thanks!

Best regards,
Marek Vasut