On Wed, Feb 10, 2016 at 03:02:45PM -0800, Tony Lindgren wrote:
> Commit 5de85b9d57ab ("PM / runtime: Re-init runtime PM states at probe
> error and driver unbind") introduced pm_runtime_reinit() that is used
> to reinitialize PM runtime after -EPROBE_DEFER. This allows shutting
> down the device after a failed probe.
> 
> However, for drivers using pm_runtime_use_autosuspend() this can cause
> a state where suspend callback is never called after -EPROBE_DEFER.
> On the following device driver probe, hardware state is different from
> the PM runtime state causing omap_device to produce the following
> error:
> 
> omap_device_enable() called from invalid state 1
> 
> And with omap_device and omap hardware being picky for PM, this will
> block any deeper idle states in hardware.
> 
> The solution is to fix the drivers to follow the PM runtime documentation:
> 
> 1. For sections of code that needs the device disabled, use
>    pm_runtime_put_sync_suspend() if pm_runtime_set_autosuspend() has
>    been set.
> 
> 2. For driver exit code, use pm_runtime_dont_use_autosuspend() before
>    pm_runtime_put_sync() if pm_runtime_use_autosuspend() has been
>    set.
> 
> Fixes: 5de85b9d57ab ("PM / runtime: Re-init runtime PM states at probe
> error and driver unbind")
> Cc: linux-i2c@vger.kernel.org
> Cc: Alan Stern <stern@rowland.harvard.edu>
> Cc: Kevin Hilman <khilman@baylibre.com>
> Cc: Nishanth Menon <nm@ti.com>
> Cc: Rafael J. Wysocki <rafael@kernel.org>
> Cc: Ulf Hansson <ulf.hansson@linaro.org>
> Cc: Tero Kristo <t-kristo@ti.com>
> Cc: Wolfram Sang <wsa@the-dreams.de>
> Signed-off-by: Tony Lindgren <tony@atomide.com>

Applied to for-current, thanks!