From mboxrd@z Thu Jan 1 00:00:00 1970 From: Rob Herring Subject: Re: [RFC 1/2] Add OV5647 device tree documentation Date: Wed, 25 May 2016 13:59:08 -0500 Message-ID: <20160525185908.GA12900@rob-hp-laptop> References: Mime-Version: 1.0 Content-Type: text/plain; charset=us-ascii Return-path: Content-Disposition: inline In-Reply-To: Sender: linux-media-owner@vger.kernel.org To: roliveir Cc: linux-media@vger.kernel.org, devicetree@vger.kernel.org, mchehab@osg.samsung.com, CARLOS.PALMINHA@synopsys.com List-Id: devicetree@vger.kernel.org On Tue, May 24, 2016 at 07:16:47PM +0100, roliveir wrote: > Signed-off-by: roliveir > --- > .../devicetree/bindings/media/i2c/ov5647.txt | 29 ++++++++++++++++++++++ > 1 file changed, 29 insertions(+) > create mode 100644 Documentation/devicetree/bindings/media/i2c/ov5647.txt > > diff --git a/Documentation/devicetree/bindings/media/i2c/ov5647.txt b/Documentation/devicetree/bindings/media/i2c/ov5647.txt > new file mode 100644 > index 0000000..fa6b09c > --- /dev/null > +++ b/Documentation/devicetree/bindings/media/i2c/ov5647.txt > @@ -0,0 +1,29 @@ > +Omnivision OV5657 raw image sensor 5657? > +--------------------------------- > + > +OV5657 is a raw image sensor with MIPI CSI-2 and CCP2 image data interfaces > +and CCI (I2C compatible) control bus. > + > +Required properties: > + > +- compatible : "ov5647"; > +- reg : I2C slave address of the sensor; > +- clocks : should contain list of phandle and clock specifier pairs > + according to common clock bindings for the clocks described > + in the clock-names property; Need to state how many clocks and the order. > +- clock-names : should contain "extclk" entry for the sensor's EXTCLK clock; > + > +Optional properties: > + > +- clock-frequency : the frequency at which the "extclk" clock should be > + configured to operate, in Hz; if this property is not > + specified default 27 MHz value will be used. > + > +The common video interfaces bindings (see video-interfaces.txt) should be > +used to specify link to the image data receiver. The OV5657 device > +node should contain one 'port' child node with an 'endpoint' subnode. > + > +Following properties are valid for the endpoint node: > + > +- data-lanes : (optional) specifies MIPI CSI-2 data lanes as covered in > + video-interfaces.txt. The sensor supports only two data lanes. > -- > 2.8.1 > >