Hi!

> > +Mandatory properties
> > +--------------------
> > +
> > +- compatible: "toshiba,et8ek8"
> > +- reg: I2C address (0x3e, or an alternative address)
> > +- vana-supply: Analogue voltage supply (VANA), 2.8 volts
> > +- clocks: External clock to the sensor
> > +- clock-frequency: Frequency of the external clock to the sensor. Camera
> > +  driver will set this frequency on the external clock.
> 
> This is fine if the frequency is fixed (e.g. an oscillator), but you 
> should use the clock binding if clocks are programable.

It is fixed. So I assume this can stay as is? Or do you want me to add
"The clock frequency is a pre-determined frequency known to be
suitable to the board." as Sakari suggests?

> > +- reset-gpios: XSHUTDOWN GPIO
> 
> Please state what the active polarity is.

As in "This gpio will be set to 1 when the chip is powered." ?

Thanks,
									Pavel
-- 
(english) http://www.livejournal.com/~pavelmachek
(cesky, pictures) http://atrey.karlin.mff.cuni.cz/~pavel/picture/horses/blog.html