On Wed 2017-02-08 15:36:09, Rob Herring wrote: > On Fri, Feb 03, 2017 at 01:35:08PM +0100, Pavel Machek wrote: > > > > N900 contains front and back camera, with a switch between the > > two. This adds support for the switch component, and it is now > > possible to select between front and back cameras during runtime. > > > > This adds documentation for the devicetree binding. > > > > Signed-off-by: Sebastian Reichel > > Signed-off-by: Ivaylo Dimitrov > > Signed-off-by: Pavel Machek > > > > > > diff --git a/Documentation/devicetree/bindings/media/video-bus-switch.txt b/Documentation/devicetree/bindings/media/video-bus-switch.txt > > new file mode 100644 > > index 0000000..1b9f8e0 > > --- /dev/null > > +++ b/Documentation/devicetree/bindings/media/video-bus-switch.txt > > @@ -0,0 +1,63 @@ > > +Video Bus Switch Binding > > +======================== > > I'd call it a mux rather than switch. It is a switch, not a multiplexor ( https://en.wikipedia.org/wiki/Multiplexing ). Only one camera can operate at a time. > BTW, there's a new mux-controller binding under review you might look > at. It would only be needed here if the mux ctrl also controls other > things. Do you have a pointer? > > +Required Port nodes > > +=================== > > + > > +More documentation on these bindings is available in > > +video-interfaces.txt in the same directory. > > + > > +reg : The interface: > > + 0 - port for image signal processor > > + 1 - port for first camera sensor > > + 2 - port for second camera sensor > > This could be used for display side as well. So describe these just as > inputs and outputs. I'd prefer not to confuse people. I guess that would be 0 -- output port, 1, 2 -- input ports... But this is media data, are you sure it is good idea to change this? Pavel -- (english) http://www.livejournal.com/~pavelmachek (cesky, pictures) http://atrey.karlin.mff.cuni.cz/~pavel/picture/horses/blog.html