All of lore.kernel.org
 help / color / mirror / Atom feed
From: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
To: Nicolas Boichat <drinkcat@chromium.org>
Cc: Alan Stern <stern@rowland.harvard.edu>,
	linux-usb@vger.kernel.org,
	Mathias Nyman <mathias.nyman@linux.intel.com>,
	Felipe Balbi <felipe.balbi@linux.intel.com>,
	Eugene Korenevsky <ekorenevsky@gmail.com>,
	Peter Chen <peter.chen@nxp.com>,
	Daniel Drake <drake@endlessm.com>, Joe Perches <joe@perches.com>,
	Johan Hovold <johan@kernel.org>,
	Richard Leitner <richard.leitner@skidata.com>,
	lkml <linux-kernel@vger.kernel.org>,
	Guenter Roeck <groeck@chromium.org>
Subject: Re: [PATCH] usb: hub: Per-port setting to use old enumeration scheme
Date: Fri, 25 May 2018 08:29:13 +0200	[thread overview]
Message-ID: <20180525062913.GA11968@kroah.com> (raw)
In-Reply-To: <CANMq1KBmE9i=Th46q06+3bY34LuLwd=U-otTxj5D9M0H2Kcaqw@mail.gmail.com>

On Fri, May 25, 2018 at 06:05:16AM +0800, Nicolas Boichat wrote:
> On Fri, May 25, 2018 at 12:21 AM, Greg Kroah-Hartman
> <gregkh@linuxfoundation.org> wrote:
> > On Thu, May 24, 2018 at 07:42:00AM +0800, Nicolas Boichat wrote:
> >> On Thu, May 24, 2018 at 12:39 AM, Greg Kroah-Hartman
> >> <gregkh@linuxfoundation.org> wrote:
> >> > On Wed, May 23, 2018 at 10:03:55AM -0400, Alan Stern wrote:
> >> >> On Wed, 23 May 2018, Nicolas Boichat wrote:
> >> >>
> >> >> > The "old" enumeration scheme is considerably faster (it takes
> >> >> > ~294ms instead of ~439ms to get the descriptor).
> >> >> >
> >> >> > It is currently only possible to use the old scheme globally
> >> >> > (/sys/module/usbcore/parameters/old_scheme_first), which is not
> >> >> > desirable as the new scheme was introduced to increase compatibility
> >> >> > with more devices.
> >> >> >
> >> >> > However, in our case, we care about time-to-active for a specific
> >> >> > USB device (which we make the firmware for), on a specific port
> >> >> > (that is pogo-pin based: not a standard USB port). This new
> >> >> > sysfs option makes it possible to use the old scheme on a single
> >> >> > port only.
> >> >> >
> >> >> > Signed-off-by: Nicolas Boichat <drinkcat@chromium.org>
> >> >> > ---
> >> >> >
> >> >> > There are other "quirks" that we could add to reduce further
> >> >> > enumeration time (e.g. reduce USB debounce time, reduce TRSTRCY
> >> >> > to 10ms instead of 50ms as used currently), but the logic is quite
> >> >> > similar, so it'd be good to have this reviewed first.
> >> >>
> >> >> I'm not opposed to the idea in principle, although I don't like your
> >> >> implementation because it breaks the original old_scheme_first
> >> >> parameter.
> >>
> >> I don't think it breaks the original parameter? I mean,
> >> /sys/module/usbcore/parameters/old_scheme_first is still a global
> >> default, while bit 0 of /sys/bus/usb/devices/x/y/z/quirks becomes a
> >> port-specific override.
> >>
> >> >> Let's see what some other people think.
> >> >>
> >> >> Yours is a rather special case, because you know exactly what device
> >> >> will be attached to a specific port.  Still, I can see that sort of
> >> >> thing happening in constrained and special-purpose settings.
> >> >>
> >> >> How do you arrange to set the new quirk before the device is
> >> >> discovered?
> >> >
> >> > Yeah, this last question is what I had when looking at this.  Or does it
> >> > not matter at first boot and only matters for wake-up?
> >>
> >> It does not matter on boot, we have plenty of time to enumerate the
> >> device. We use USB (auto-)suspend and remote wake, so no
> >> re-enumeration there either. It only matters on unplug/replug where
> >> the device needs to be re-enumerated.
> >
> > How does this device get unplugged/replugged if it is connected directly
> > to the device?
> 
> It is external. Essentially, this is a tablet with a detachable
> keyboard/touchpad. The interface between tablet and base is USB, over
> pogo pins. The port is non-standard (pogo, not normal USB), and we
> fully control the firmware on the base side as well, which allows us
> to take shortcuts like this: we know exactly what device will be
> connected on that port.

Ah, ok, that makes more sense, thanks for the explanation.  I'll go
queue this up in a bit.

greg k-h

WARNING: multiple messages have this Message-ID
From: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
To: Nicolas Boichat <drinkcat@chromium.org>
Cc: Alan Stern <stern@rowland.harvard.edu>,
	linux-usb@vger.kernel.org,
	Mathias Nyman <mathias.nyman@linux.intel.com>,
	Felipe Balbi <felipe.balbi@linux.intel.com>,
	Eugene Korenevsky <ekorenevsky@gmail.com>,
	Peter Chen <peter.chen@nxp.com>,
	Daniel Drake <drake@endlessm.com>, Joe Perches <joe@perches.com>,
	Johan Hovold <johan@kernel.org>,
	Richard Leitner <richard.leitner@skidata.com>,
	lkml <linux-kernel@vger.kernel.org>,
	Guenter Roeck <groeck@chromium.org>
Subject: usb: hub: Per-port setting to use old enumeration scheme
Date: Fri, 25 May 2018 08:29:13 +0200	[thread overview]
Message-ID: <20180525062913.GA11968@kroah.com> (raw)

On Fri, May 25, 2018 at 06:05:16AM +0800, Nicolas Boichat wrote:
> On Fri, May 25, 2018 at 12:21 AM, Greg Kroah-Hartman
> <gregkh@linuxfoundation.org> wrote:
> > On Thu, May 24, 2018 at 07:42:00AM +0800, Nicolas Boichat wrote:
> >> On Thu, May 24, 2018 at 12:39 AM, Greg Kroah-Hartman
> >> <gregkh@linuxfoundation.org> wrote:
> >> > On Wed, May 23, 2018 at 10:03:55AM -0400, Alan Stern wrote:
> >> >> On Wed, 23 May 2018, Nicolas Boichat wrote:
> >> >>
> >> >> > The "old" enumeration scheme is considerably faster (it takes
> >> >> > ~294ms instead of ~439ms to get the descriptor).
> >> >> >
> >> >> > It is currently only possible to use the old scheme globally
> >> >> > (/sys/module/usbcore/parameters/old_scheme_first), which is not
> >> >> > desirable as the new scheme was introduced to increase compatibility
> >> >> > with more devices.
> >> >> >
> >> >> > However, in our case, we care about time-to-active for a specific
> >> >> > USB device (which we make the firmware for), on a specific port
> >> >> > (that is pogo-pin based: not a standard USB port). This new
> >> >> > sysfs option makes it possible to use the old scheme on a single
> >> >> > port only.
> >> >> >
> >> >> > Signed-off-by: Nicolas Boichat <drinkcat@chromium.org>
> >> >> > ---
> >> >> >
> >> >> > There are other "quirks" that we could add to reduce further
> >> >> > enumeration time (e.g. reduce USB debounce time, reduce TRSTRCY
> >> >> > to 10ms instead of 50ms as used currently), but the logic is quite
> >> >> > similar, so it'd be good to have this reviewed first.
> >> >>
> >> >> I'm not opposed to the idea in principle, although I don't like your
> >> >> implementation because it breaks the original old_scheme_first
> >> >> parameter.
> >>
> >> I don't think it breaks the original parameter? I mean,
> >> /sys/module/usbcore/parameters/old_scheme_first is still a global
> >> default, while bit 0 of /sys/bus/usb/devices/x/y/z/quirks becomes a
> >> port-specific override.
> >>
> >> >> Let's see what some other people think.
> >> >>
> >> >> Yours is a rather special case, because you know exactly what device
> >> >> will be attached to a specific port.  Still, I can see that sort of
> >> >> thing happening in constrained and special-purpose settings.
> >> >>
> >> >> How do you arrange to set the new quirk before the device is
> >> >> discovered?
> >> >
> >> > Yeah, this last question is what I had when looking at this.  Or does it
> >> > not matter at first boot and only matters for wake-up?
> >>
> >> It does not matter on boot, we have plenty of time to enumerate the
> >> device. We use USB (auto-)suspend and remote wake, so no
> >> re-enumeration there either. It only matters on unplug/replug where
> >> the device needs to be re-enumerated.
> >
> > How does this device get unplugged/replugged if it is connected directly
> > to the device?
> 
> It is external. Essentially, this is a tablet with a detachable
> keyboard/touchpad. The interface between tablet and base is USB, over
> pogo pins. The port is non-standard (pogo, not normal USB), and we
> fully control the firmware on the base side as well, which allows us
> to take shortcuts like this: we know exactly what device will be
> connected on that port.

Ah, ok, that makes more sense, thanks for the explanation.  I'll go
queue this up in a bit.

greg k-h
---
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html

  reply	other threads:[~2018-05-25  6:29 UTC|newest]

Thread overview: 18+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2018-05-23  2:16 Nicolas Boichat
2018-05-23  2:16 ` Nicolas Boichat
2018-05-23 14:03 ` [PATCH] " Alan Stern
2018-05-23 14:03   ` Alan Stern
2018-05-23 16:39   ` [PATCH] " Greg Kroah-Hartman
2018-05-23 16:39     ` Greg Kroah-Hartman
2018-05-23 23:42     ` [PATCH] " Nicolas Boichat
2018-05-23 23:42       ` Nicolas Boichat
2018-05-24 14:29       ` [PATCH] " Alan Stern
2018-05-24 14:29         ` Alan Stern
2018-05-24 16:21       ` [PATCH] " Greg Kroah-Hartman
2018-05-24 16:21         ` Greg Kroah-Hartman
2018-05-24 22:05         ` [PATCH] " Nicolas Boichat
2018-05-24 22:05           ` Nicolas Boichat
2018-05-25  6:29           ` Greg Kroah-Hartman [this message]
2018-05-25  6:29             ` Greg Kroah-Hartman
2018-05-25  6:30 ` [PATCH] " Greg Kroah-Hartman
2018-05-25  6:30   ` Greg Kroah-Hartman

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20180525062913.GA11968@kroah.com \
    --to=gregkh@linuxfoundation.org \
    --cc=drake@endlessm.com \
    --cc=drinkcat@chromium.org \
    --cc=ekorenevsky@gmail.com \
    --cc=felipe.balbi@linux.intel.com \
    --cc=groeck@chromium.org \
    --cc=joe@perches.com \
    --cc=johan@kernel.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-usb@vger.kernel.org \
    --cc=mathias.nyman@linux.intel.com \
    --cc=peter.chen@nxp.com \
    --cc=richard.leitner@skidata.com \
    --cc=stern@rowland.harvard.edu \
    --subject='Re: [PATCH] usb: hub: Per-port setting to use old enumeration scheme' \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link

This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.