All of lore.kernel.org
 help / color / mirror / Atom feed
From: Boris Brezillon <boris.brezillon@bootlin.com>
To: Stefan Agner <stefan@agner.ch>
Cc: mark.rutland@arm.com, benjamin.lindqvist@endian.se,
	pgaikwad@nvidia.com, dev@lynxeye.de, mirza.krak@gmail.com,
	richard@nod.at, pdeschrijver@nvidia.com,
	linux-kernel@vger.kernel.org, krzk@kernel.org,
	jonathanh@nvidia.com, marek.vasut@gmail.com,
	devicetree@vger.kernel.org, robh+dt@kernel.org,
	thierry.reding@gmail.com, marcel@ziswiler.com,
	miquel.raynal@bootlin.com, linux-tegra@vger.kernel.org,
	linux-mtd@lists.infradead.org, Dmitry Osipenko <digetx@gmail.com>,
	computersforpeace@gmail.com, dwmw2@infradead.org
Subject: Re: [PATCH v3 4/6] mtd: rawnand: add NVIDIA Tegra NAND Flash controller driver
Date: Sat, 9 Jun 2018 08:46:15 +0200	[thread overview]
Message-ID: <20180609084615.6fba31ec@bbrezillon> (raw)
In-Reply-To: <20180609084157.0c2f12e6@bbrezillon>

On Sat, 9 Jun 2018 08:41:57 +0200
Boris Brezillon <boris.brezillon@bootlin.com> wrote:

> On Sat, 09 Jun 2018 08:23:51 +0200
> Stefan Agner <stefan@agner.ch> wrote:
> 
> > On 09.06.2018 07:52, Boris Brezillon wrote:
> > > On Fri, 08 Jun 2018 23:51:01 +0200
> > > Stefan Agner <stefan@agner.ch> wrote:
> > > 
> > >   
> > >> >
> > >> > void tegra_nand_controller_reset(struct tegra_nand_controller *ctrl)
> > >> > {
> > >> > 	int err;
> > >> >
> > >> > 	disable_irq(ctrl->irq);
> > >> >
> > >> > 	err = reset_control_reset(ctrl->rst);
> > >> > 	if (err) {
> > >> > 		dev_err(ctrl->dev, "Failed to reset HW: %d\n", err);
> > >> > 		msleep(HW_TIMEOUT);
> > >> > 	}
> > >> >
> > >> > 	writel_relaxed(NAND_CMD_STATUS, ctrl->regs + HWSTATUS_CMD);
> > >> > 	writel_relaxed(HWSTATUS_MASK, ctrl->regs + HWSTATUS_MASK);
> > >> > 	writel_relaxed(INT_MASK, ctrl->regs + ISR);  
> > >>
> > >> If we do a controller reset, there is much more state than that which
> > >> needs to be restored. A lot of it is not readily available currently
> > >> (timing, ECC settings...)  
> > > 
> > > This is actually a good test to detect what is not properly initialized
> > > by the driver. Timings should be configured correctly through  
> > > ->setup_data_interface(). ECC engine should be disabled by default and  
> > > only enabled when ->{read,write}_page() is called.
> > >   
> > 
> > Is setup_data_interface guaranteed to be called after a failed
> > ->exec_op()/{read,write}_page()?
> 
> No. Maybe I misunderstood when tegra_nand_controller_reset() was
> supposed to be called. That's something I would call only once, early
> in the probe function, so that the controller is placed in a well-known
> state before we start using it. Definitely not something you should
> call after each error.

Note that if you really want to reset the controller after an error,
you should also iterate over all chips and call nand_reset() on them.

  reply	other threads:[~2018-06-09  6:46 UTC|newest]

Thread overview: 43+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2018-05-31 22:16 [PATCH v3 0/6] mtd: rawnand: add NVIDIA Tegra NAND flash support Stefan Agner
2018-05-31 22:16 ` [PATCH v3 1/6] mtd: rawnand: add Reed-Solomon error correction algorithm Stefan Agner
2018-06-01  7:26   ` Boris Brezillon
2018-06-01  9:25     ` Boris Brezillon
2018-06-01 13:34       ` Stefan Agner
2018-06-01 13:43         ` Boris Brezillon
2018-05-31 22:16 ` [PATCH v3 2/6] mtd: rawnand: add an option to specify NAND chip as a boot device Stefan Agner
2018-06-01  7:26   ` Boris Brezillon
2018-06-05 20:11   ` Rob Herring
2018-06-06  7:28     ` Boris Brezillon
2018-05-31 22:16 ` [PATCH v3 3/6] mtd: rawnand: tegra: add devicetree binding Stefan Agner
2018-06-01  7:30   ` Boris Brezillon
2018-06-05 20:19     ` Dmitry Osipenko
2018-06-06 10:39       ` Thierry Reding
2018-06-06 10:45         ` Boris Brezillon
2018-06-06 11:07           ` Thierry Reding
2018-06-06 12:14             ` Stefan Agner
2018-06-06 12:31               ` Boris Brezillon
2018-06-05 20:13   ` Rob Herring
2018-05-31 22:16 ` [PATCH v3 4/6] mtd: rawnand: add NVIDIA Tegra NAND Flash controller driver Stefan Agner
2018-06-01  9:20   ` Dmitry Osipenko
2018-06-08 21:51     ` Stefan Agner
2018-06-09  5:52       ` Boris Brezillon
2018-06-09  6:23         ` Stefan Agner
2018-06-09  6:41           ` Boris Brezillon
2018-06-09  6:46             ` Boris Brezillon [this message]
2018-06-09  6:55               ` Boris Brezillon
2018-06-09  6:51             ` Stefan Agner
2018-06-09 12:21       ` Dmitry Osipenko
2018-06-10 11:09         ` Stefan Agner
2018-06-10 15:00           ` Dmitry Osipenko
2018-06-10 15:32             ` Boris Brezillon
2018-06-11 11:45               ` Dmitry Osipenko
2018-06-11 11:50                 ` Boris Brezillon
2018-06-11 13:10                   ` Dmitry Osipenko
2018-06-04 17:16   ` Randolph Maaßen
2018-06-04 17:16     ` Randolph Maaßen
2018-06-04 17:16     ` Randolph Maaßen
2018-06-04 20:56     ` Stefan Agner
2018-06-09  5:55   ` Boris Brezillon
2018-06-09  7:18   ` Boris Brezillon
2018-05-31 22:16 ` [PATCH v3 5/6] ARM: dts: tegra: add Tegra20 NAND flash controller node Stefan Agner
2018-05-31 22:16 ` [PATCH v3 6/6] ARM: dts: tegra: enable NAND flash on Colibri T20 Stefan Agner

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20180609084615.6fba31ec@bbrezillon \
    --to=boris.brezillon@bootlin.com \
    --cc=benjamin.lindqvist@endian.se \
    --cc=computersforpeace@gmail.com \
    --cc=dev@lynxeye.de \
    --cc=devicetree@vger.kernel.org \
    --cc=digetx@gmail.com \
    --cc=dwmw2@infradead.org \
    --cc=jonathanh@nvidia.com \
    --cc=krzk@kernel.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-mtd@lists.infradead.org \
    --cc=linux-tegra@vger.kernel.org \
    --cc=marcel@ziswiler.com \
    --cc=marek.vasut@gmail.com \
    --cc=mark.rutland@arm.com \
    --cc=miquel.raynal@bootlin.com \
    --cc=mirza.krak@gmail.com \
    --cc=pdeschrijver@nvidia.com \
    --cc=pgaikwad@nvidia.com \
    --cc=richard@nod.at \
    --cc=robh+dt@kernel.org \
    --cc=stefan@agner.ch \
    --cc=thierry.reding@gmail.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.