From mboxrd@z Thu Jan 1 00:00:00 1970 From: gerg@kernel.org Subject: [PATCHv2 3/4] net: dsa: mt7530: support the 7530 switch on the Mediatek MT7621 SoC Date: Mon, 14 Jan 2019 17:03:33 +1000 Message-ID: <20190114070334.20478-4-gerg@kernel.org> References: <20190114070334.20478-1-gerg@kernel.org> Cc: rene@vdorst.com, john@phrozen.org, neil@brown.name, Greg Ungerer To: sean.wang@mediatek.com, bjorn@mork.no, andrew@lunn.ch, vivien.didelot@savoirfairelinux.com, f.fainelli@gmail.com, netdev@vger.kernel.org Return-path: Received: from mail.kernel.org ([198.145.29.99]:47816 "EHLO mail.kernel.org" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1726460AbfANHEq (ORCPT ); Mon, 14 Jan 2019 02:04:46 -0500 In-Reply-To: <20190114070334.20478-1-gerg@kernel.org> Sender: netdev-owner@vger.kernel.org List-ID: From: Greg Ungerer The MediaTek MT7621 SoC device contains a 7530 switch, and the existing linux kernel 7530 DSA switch driver can be used with it. The bulk of the changes required stem from the 7621 having different regulator and pad setup. The existing setup of these in the 7530 driver appears to be very specific to its implemtation in the Mediatek 7623 SoC. (Not entirely surprising given the 7623 is a quad core ARM based SoC, and the 7621 is a dual core, dual thread MIPS based SoC). Create a new devicetree type, "mediatek,mt7621", to support the 7530 switch in the 7621 SoC. There appears to be no usable ID register to distinguish it from a 7530 in other hardware at runtime. This is used to carry out the appropriate configuration and setup. Signed-off-by: Greg Ungerer --- drivers/net/dsa/mt7530.c | 97 ++++++++++++++++++++++++---------------- drivers/net/dsa/mt7530.h | 9 ++++ 2 files changed, 67 insertions(+), 39 deletions(-) v1: initial patch v2: changed to use separate devicetree binding diff --git a/drivers/net/dsa/mt7530.c b/drivers/net/dsa/mt7530.c index 74547f43b938..c396665e576c 100644 --- a/drivers/net/dsa/mt7530.c +++ b/drivers/net/dsa/mt7530.c @@ -622,17 +622,19 @@ static void mt7530_adjust_link(struct dsa_switch *ds, int port, struct mt7530_priv *priv = ds->priv; if (phy_is_pseudo_fixed_link(phydev)) { - dev_dbg(priv->dev, "phy-mode for master device = %x\n", - phydev->interface); - - /* Setup TX circuit incluing relevant PAD and driving */ - mt7530_pad_clk_setup(ds, phydev->interface); - - /* Setup RX circuit, relevant PAD and driving on the host - * which must be placed after the setup on the device side is - * all finished. - */ - mt7623_pad_clk_setup(ds); + if (priv->id == ID_MT7530) { + dev_dbg(priv->dev, "phy-mode for master device = %x\n", + phydev->interface); + + /* Setup TX circuit incluing relevant PAD and driving */ + mt7530_pad_clk_setup(ds, phydev->interface); + + /* Setup RX circuit, relevant PAD and driving on the + * host which must be placed after the setup on the + * device side is all finished. + */ + mt7623_pad_clk_setup(ds); + } } else { u16 lcl_adv = 0, rmt_adv = 0; u8 flowctrl; @@ -688,6 +690,10 @@ mt7530_cpu_port_enable(struct mt7530_priv *priv, /* Unknown unicast frame fordwarding to the cpu port */ mt7530_set(priv, MT7530_MFC, UNU_FFP(BIT(port))); + /* Set CPU port number */ + if (priv->id == ID_MT7621) + mt7530_rmw(priv, MT7530_MFC, CPU_MASK, CPU_EN | CPU_PORT(port)); + /* CPU port gets connected to all user ports of * the switch */ @@ -1220,24 +1226,27 @@ mt7530_setup(struct dsa_switch *ds) * as two netdev instances. */ dn = ds->ports[MT7530_CPU_PORT].master->dev.of_node->parent; - priv->ethernet = syscon_node_to_regmap(dn); - if (IS_ERR(priv->ethernet)) - return PTR_ERR(priv->ethernet); - regulator_set_voltage(priv->core_pwr, 1000000, 1000000); - ret = regulator_enable(priv->core_pwr); - if (ret < 0) { - dev_err(priv->dev, - "Failed to enable core power: %d\n", ret); - return ret; - } + if (priv->id == ID_MT7530) { + priv->ethernet = syscon_node_to_regmap(dn); + if (IS_ERR(priv->ethernet)) + return PTR_ERR(priv->ethernet); + + regulator_set_voltage(priv->core_pwr, 1000000, 1000000); + ret = regulator_enable(priv->core_pwr); + if (ret < 0) { + dev_err(priv->dev, + "Failed to enable core power: %d\n", ret); + return ret; + } - regulator_set_voltage(priv->io_pwr, 3300000, 3300000); - ret = regulator_enable(priv->io_pwr); - if (ret < 0) { - dev_err(priv->dev, "Failed to enable io pwr: %d\n", - ret); - return ret; + regulator_set_voltage(priv->io_pwr, 3300000, 3300000); + ret = regulator_enable(priv->io_pwr); + if (ret < 0) { + dev_err(priv->dev, "Failed to enable io pwr: %d\n", + ret); + return ret; + } } /* Reset whole chip through gpio pin or memory-mapped registers for @@ -1327,9 +1336,17 @@ static const struct dsa_switch_ops mt7530_switch_ops = { .port_vlan_del = mt7530_port_vlan_del, }; +static const struct of_device_id mt7530_of_match[] = { + { .compatible = "mediatek,mt7621", .data = (void *)ID_MT7621, }, + { .compatible = "mediatek,mt7530", .data = (void *)ID_MT7530, }, + { /* sentinel */ }, +}; +MODULE_DEVICE_TABLE(of, mt7530_of_match); + static int mt7530_probe(struct mdio_device *mdiodev) { + const struct of_device_id *of_id; struct mt7530_priv *priv; struct device_node *dn; @@ -1357,13 +1374,21 @@ mt7530_probe(struct mdio_device *mdiodev) } } - priv->core_pwr = devm_regulator_get(&mdiodev->dev, "core"); - if (IS_ERR(priv->core_pwr)) - return PTR_ERR(priv->core_pwr); + /* Get the hardware identifier from the devicetree node. + * We will need it for some of the clock and regulator setup. + */ + of_id = of_match_node(mt7530_of_match, dn); + priv->id = (unsigned int)of_id->data; - priv->io_pwr = devm_regulator_get(&mdiodev->dev, "io"); - if (IS_ERR(priv->io_pwr)) - return PTR_ERR(priv->io_pwr); + if (priv->id == ID_MT7530) { + priv->core_pwr = devm_regulator_get(&mdiodev->dev, "core"); + if (IS_ERR(priv->core_pwr)) + return PTR_ERR(priv->core_pwr); + + priv->io_pwr = devm_regulator_get(&mdiodev->dev, "io"); + if (IS_ERR(priv->io_pwr)) + return PTR_ERR(priv->io_pwr); + } /* Not MCM that indicates switch works as the remote standalone * integrated circuit so the GPIO pin would be used to complete @@ -1409,12 +1434,6 @@ mt7530_remove(struct mdio_device *mdiodev) mutex_destroy(&priv->reg_mutex); } -static const struct of_device_id mt7530_of_match[] = { - { .compatible = "mediatek,mt7530" }, - { /* sentinel */ }, -}; -MODULE_DEVICE_TABLE(of, mt7530_of_match); - static struct mdio_driver mt7530_mdio_driver = { .probe = mt7530_probe, .remove = mt7530_remove, diff --git a/drivers/net/dsa/mt7530.h b/drivers/net/dsa/mt7530.h index d9b407a22a58..a95ed958df5b 100644 --- a/drivers/net/dsa/mt7530.h +++ b/drivers/net/dsa/mt7530.h @@ -19,6 +19,11 @@ #define MT7530_NUM_FDB_RECORDS 2048 #define MT7530_ALL_MEMBERS 0xff +enum { + ID_MT7530 = 0, + ID_MT7621 = 1, +}; + #define NUM_TRGMII_CTRL 5 #define TRGMII_BASE(x) (0x10000 + (x)) @@ -36,6 +41,9 @@ #define UNM_FFP(x) (((x) & 0xff) << 16) #define UNU_FFP(x) (((x) & 0xff) << 8) #define UNU_FFP_MASK UNU_FFP(~0) +#define CPU_EN BIT(7) +#define CPU_PORT(x) ((x) << 4) +#define CPU_MASK (0xf << 4) /* Registers for address table access */ #define MT7530_ATA1 0x74 @@ -430,6 +438,7 @@ struct mt7530_priv { struct regulator *core_pwr; struct regulator *io_pwr; struct gpio_desc *reset; + unsigned int id; bool mcm; struct mt7530_port ports[MT7530_NUM_PORTS]; -- 2.17.1