On Mon, Jan 21, 2019 at 04:21:03PM +0000, Peter Maydell wrote:
> On Thu, 10 Jan 2019 at 09:40, Stefan Hajnoczi <stefanha@redhat.com> wrote:
> >
> > v2:
> >  * Move stub code into a separate device [Peter]
> >  * Instantiate stub from microbit board instead of nRF51 SoC since this is
> >    microbit-specific.  Other boards using the nRF51 wouldn't necessarily want
> >    to see these TWI/I2C devices.
> >  * Add test case
> >
> > This series stubs out the microbit's TWI/I2C devices so the microbit-dal
> > firmware boots successfully.  The accelerometer and magnetometer are probed at
> > startup.  If they are not found the firmware panics.
> >
> > Stefan Hajnoczi (1):
> >   tests/microbit-test: add TWI stub device test
> >
> > Steffen Görtz (1):
> >   arm: Stub out NRF51 TWI magnetometer/accelerometer detection
> >
> >  hw/i2c/Makefile.objs          |   1 +
> >  include/hw/arm/nrf51.h        |   2 +
> >  include/hw/arm/nrf51_soc.h    |   1 +
> >  include/hw/i2c/microbit_i2c.h |  42 +++++++++++
> >  hw/arm/microbit.c             |  15 ++++
> >  hw/i2c/microbit_i2c.c         | 127 ++++++++++++++++++++++++++++++++++
> >  tests/microbit-test.c         |  44 ++++++++++++
> >  7 files changed, 232 insertions(+)
> >  create mode 100644 include/hw/i2c/microbit_i2c.h
> >  create mode 100644 hw/i2c/microbit_i2c.c
> 
> Applied to target-arm.next, thanks. Can you provide a
> MAINTAINERS file update for the new files, please?
> (You can send that separately or stick it in another
> nrf51 series if you're sending one.)

Sure, will do.

Stefan