From mboxrd@z Thu Jan 1 00:00:00 1970 From: Sjoerd Simons Date: Tue, 4 Jun 2019 15:49:57 +0200 Subject: [U-Boot] [PATCH 2/3] mx6sabreauto: set SYS_MALLOC_F for video In-Reply-To: <20190604134958.17419-1-sjoerd.simons@collabora.co.uk> References: <20190604134958.17419-1-sjoerd.simons@collabora.co.uk> Message-ID: <20190604134958.17419-3-sjoerd.simons@collabora.co.uk> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Sabre Auto boards currently hang with: ``` U-Boot 2019.07-rc3-00057-gc41940c406 (Jun 03 2019 - 14:42:41 +0200) CPU: Freescale i.MX6QP rev1.0 996 MHz (running at 792 MHz) CPU: Automotive temperature grade (-40C to 125C)Reset cause: WDOG Model: Freescale i.MX6 Quad Plus SABRE Automotive Board Board: MX6Q-Sabreauto revA I2C: ready DRAM: 2 GiB Video device 'ipu at 2400000' cannot allocate frame buffer memory -ensure the device is set up before relocation Error binding driver 'ipuv3_video': -28 Video device 'ipu at 2800000' cannot allocate frame buffer memory -ensure the device is set up before relocation Error binding driver 'ipuv3_video': -28 Some drivers failed to bind Error binding driver 'generic_simple_bus': -28 Some drivers failed to bind initcall sequence 8ffe00b8 failed at call 1780e93b (err=-28) ``` Set SYS_MALLOC_F_LEN to reserve_video to work. This is similar to the change Peng Fan did for mx6sabresd (9002e735e717) Signed-off-by: Sjoerd Simons Reviewed-by: Peng Fan --- configs/mx6sabreauto_defconfig | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/configs/mx6sabreauto_defconfig b/configs/mx6sabreauto_defconfig index ef965a30e6..dc758d7aaf 100644 --- a/configs/mx6sabreauto_defconfig +++ b/configs/mx6sabreauto_defconfig @@ -4,6 +4,7 @@ CONFIG_SYS_TEXT_BASE=0x17800000 CONFIG_SPL_GPIO_SUPPORT=y CONFIG_SPL_LIBCOMMON_SUPPORT=y CONFIG_SPL_LIBGENERIC_SUPPORT=y +CONFIG_SYS_MALLOC_F_LEN=0x4000 CONFIG_TARGET_MX6SABREAUTO=y CONFIG_SPL_MMC_SUPPORT=y CONFIG_SPL_SERIAL_SUPPORT=y @@ -11,7 +12,6 @@ CONFIG_NR_DRAM_BANKS=1 CONFIG_SPL=y CONFIG_SPL_LIBDISK_SUPPORT=y CONFIG_NXP_BOARD_REVISION=y -# CONFIG_SYS_MALLOC_F is not set CONFIG_FIT=y CONFIG_SPL_FIT_PRINT=y CONFIG_SPL_LOAD_FIT=y -- 2.20.1