[PATCH] ARM: dts: imx53-qsb: Use DRM bindings for the Seiko 43WVF1G panel

* [PATCH] ARM: dts: imx53-qsb: Use DRM bindings for the Seiko 43WVF1G panel
@ 2019-10-24 21:57 Fabio Estevam
  2019-10-28 11:55 ` Shawn Guo
  0 siblings, 1 reply; 2+ messages in thread
From: Fabio Estevam @ 2019-10-24 21:57 UTC (permalink / raw)
  To: shawnguo; +Cc: s.hauer, Fabio Estevam, linux-imx, linux-arm-kernel

Currently the parallel panel that is supported is the CLAA WVGA panel,
which is the one that comes with the i.MX51 Babbage board.

The default parallel panel that goes with the imx53-qsb board is
the Seiko 43WVF1G LCD, so switch to the Seiko one.

While at it convert to DRM bindings.

The parallel display still remains disabled as the default display
port is the TVE output.

Signed-off-by: Fabio Estevam <festevam@gmail.com>
---
 arch/arm/boot/dts/imx53-qsb-common.dtsi | 44 ++++++++++++++-----------
 1 file changed, 24 insertions(+), 20 deletions(-)

diff --git a/arch/arm/boot/dts/imx53-qsb-common.dtsi b/arch/arm/boot/dts/imx53-qsb-common.dtsi
index f00dda334976..9b4efcd82636 100644
--- a/arch/arm/boot/dts/imx53-qsb-common.dtsi
+++ b/arch/arm/boot/dts/imx53-qsb-common.dtsi
@@ -18,34 +18,28 @@
 
 	display0: disp0 {
 		compatible = "fsl,imx-parallel-display";
-		interface-pix-fmt = "rgb565";
 		pinctrl-names = "default";
 		pinctrl-0 = <&pinctrl_ipu_disp0>;
+
+		#address-cells = <1>;
+		#size-cells = <0>;
 		status = "disabled";
-		display-timings {
-			claawvga {
-				native-mode;
-				clock-frequency = <27000000>;
-				hactive = <800>;
-				vactive = <480>;
-				hback-porch = <40>;
-				hfront-porch = <60>;
-				vback-porch = <10>;
-				vfront-porch = <10>;
-				hsync-len = <20>;
-				vsync-len = <10>;
-				hsync-active = <0>;
-				vsync-active = <0>;
-				de-active = <1>;
-				pixelclk-active = <0>;
-			};
-		};
 
-		port {
+		port@0 {
+			reg = <0>;
+
 			display0_in: endpoint {
 				remote-endpoint = <&ipu_di0_disp0>;
 			};
 		};
+
+		port@1 {
+			reg = <1>;
+
+			display_out: endpoint {
+				remote-endpoint = <&panel_in>;
+			};
+		};
 	};
 
 	gpio-keys {
@@ -84,6 +78,16 @@
 		};
 	};
 
+	panel {
+		compatible = "sii,43wvf1g";
+
+		port {
+			panel_in: endpoint {
+				remote-endpoint = <&display_out>;
+			};
+		};
+	};
+
 	regulators {
 		compatible = "simple-bus";
 		#address-cells = <1>;
-- 
2.17.1


_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel

^ permalink raw reply related	[flat|nested] 2+ messages in thread