[PATCH 4.9 02/34] regulator: pfuze100-regulator: Variable "val" in pfuze100_regulator_probe() could be uninitialized

[Greg Kroah-Hartman <gregkh@linuxfoundation.org>]

From: Yizhuo <yzhai003@ucr.edu>

[ Upstream commit 1252b283141f03c3dffd139292c862cae10e174d ]

In function pfuze100_regulator_probe(), variable "val" could be
initialized if regmap_read() fails. However, "val" is used to
decide the control flow later in the if statement, which is
potentially unsafe.

Signed-off-by: Yizhuo <yzhai003@ucr.edu>
Link: https://lore.kernel.org/r/20190929170957.14775-1-yzhai003@ucr.edu
Signed-off-by: Mark Brown <broonie@kernel.org>
Signed-off-by: Sasha Levin <sashal@kernel.org>
---
 drivers/regulator/pfuze100-regulator.c | 8 +++++++-
 1 file changed, 7 insertions(+), 1 deletion(-)

diff --git a/drivers/regulator/pfuze100-regulator.c b/drivers/regulator/pfuze100-regulator.c
index 86b348740fcdc..ffb1f61d2c752 100644
--- a/drivers/regulator/pfuze100-regulator.c
+++ b/drivers/regulator/pfuze100-regulator.c
@@ -608,7 +608,13 @@ static int pfuze100_regulator_probe(struct i2c_client *client,
 
 		/* SW2~SW4 high bit check and modify the voltage value table */
 		if (i >= sw_check_start && i <= sw_check_end) {
-			regmap_read(pfuze_chip->regmap, desc->vsel_reg, &val);
+			ret = regmap_read(pfuze_chip->regmap,
+						desc->vsel_reg, &val);
+			if (ret) {
+				dev_err(&client->dev, "Fails to read from the register.\n");
+				return ret;
+			}
+
 			if (val & sw_hi) {
 				if (pfuze_chip->chip_id == PFUZE3000) {
 					desc->volt_table = pfuze3000_sw2hi;
-- 
2.20.1