From mboxrd@z Thu Jan 1 00:00:00 1970 From: Tom Rini Date: Sat, 7 Dec 2019 13:25:00 -0500 Subject: i.MX8MM-EVK Boot failure In-Reply-To: References: Message-ID: <20191207182500.GU9549@bill-the-cat> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On Sat, Dec 07, 2019 at 08:42:32AM -0600, Adam Ford wrote: > I am trying to run the latest master > > 4b19b89ca4a866b7baa642533e6dbd67cd832d27 > with the clock patches applied for 8mm, but I am getting a boot > failure when I follow the instructions in the README, which are also a > bit wrong. (the firmware versions don't match, and the ./firmware > command is missing the trailing '.bin', but it's trivial.) > > What comes out of the kit with DEBUG enabled is: > > (bunch of stuff deleted) > > [PMU Major message = 0x000000fe] > [PMU Major message = 0x00000007] > Training PASS > DDRINFO: ddrphy config done > DDRINFO:ddrphy calibration done > DDRINFO: ddrmix config done > >>SPL: board_init_r() > using memory lx-lx for malloc() > spl_init > Normal Boot > Trying to boot from MMC1 > common/dlmalloc.c:792: do_check_inuse_chunk: Assertion `inuse(p)' failed. > resetting ... > > The above sequence repeats again and again. I didn't put all the junk > into the log because it looked like everything seemed OK until the > dlmalloc failure at the end. If someone has any suggestions, I'd like > to try the 8mm-evk with a modern U-Boot. I think (per the thread about fixing one of the colibri platforms) this also needs a CONFIG_FSL_ESDHC -> CONFIG_FSL_ESDHC_IMX fix in the board file. -- Tom -------------- next part -------------- A non-text attachment was scrubbed... Name: signature.asc Type: application/pgp-signature Size: 833 bytes Desc: not available URL: