From mboxrd@z Thu Jan 1 00:00:00 1970 From: Biwen Li Date: Thu, 19 Dec 2019 15:02:19 +0800 Subject: [v5 4/8] Kconfigs: layerscape: use a convenient default value for SYS_MALLOC_F_LEN In-Reply-To: <20191219070223.31948-1-biwen.li@nxp.com> References: <20191219070223.31948-1-biwen.li@nxp.com> Message-ID: <20191219070223.31948-4-biwen.li@nxp.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de The default value of CONFIG_SYS_MALLOC_F_LEN (0x400) leaves U-Boot with not enough memory to load i2c driver before relocate, causing it to hang. Change the default value of CONFIG_SYS_MALLOC_F_LEN for below SoCs, - LS1012A - LS1021A - LS1043A - LS1046A Reviewed-by: Priyanka Jain Signed-off-by: Biwen Li --- Changes in v5: - none Changes in v4: - none Changes in v3: - update commit messages Changes in v2: - none Kconfig | 4 +++- 1 file changed, 3 insertions(+), 1 deletion(-) diff --git a/Kconfig b/Kconfig index 92fc4fc135..3253428bbf 100644 --- a/Kconfig +++ b/Kconfig @@ -147,7 +147,9 @@ config SYS_MALLOC_F_LEN default 0x1000 if AM33XX default 0x2800 if SANDBOX default 0x2000 if (ARCH_IMX8 || ARCH_IMX8M || ARCH_MX7 || \ - ARCH_MX7ULP || ARCH_MX6 || ARCH_MX5) + ARCH_MX7ULP || ARCH_MX6 || ARCH_MX5 || \ + ARCH_LS1012A || ARCH_LS1021A || ARCH_LS1043A || \ + ARCH_LS1046A) default 0x400 help Before relocation, memory is very limited on many platforms. Still, -- 2.17.1