On Mon, Feb 17, 2020 at 05:18:10PM +0800, Ramuthevar, Vadivel MuruganX wrote:
> On 14/2/2020 9:09 PM, Mark Brown wrote:

> > This will unconditionally handle the interrupt regardless of if the
> > hardware was actually flagging an interrupt which will break shared
> > interrupts and the fault handling code in genirq.

> Yes, you're correct, it doesn't check unconditionally, will update the
> INT flag in the INT_STATUS register after successful completion of
> read/write operation.
> but in this case it is dedicated to qspi-interrupt,not shared with any other
> HW/SW interrupts.

Currently, on the system you're looking at.  Given that this is already
a widely reused IP there's no guarantee that this will always be the
case, and like I say even without sharing it also defeats the fault
handling code.