Re: [PATCH] drivers/of/of_mdio.c:fix of_mdiobus_register()

[Andrew Lunn <andrew@lunn.ch>]

Hi Dajun

> This is my test in Xilinx zcu106 board.
> 
> dts is liks this:
> ethernet@ff0e0000 {
>     compatible = "cdns,zynqmp-gem", "cdns,gem";
>     status = "okay";
>     ...
>     
>     phy@0 {
>         ti,rx-internal-delay = <0x8>;
>         ti,tx-internal-delay = <0xa>;
>         ti,fifo-depth = <0x1>;
>         ti,rxctrl-strap-worka;
>         linux,phandle = <0x12>;
>         phandle = <0x12>;
>     };
> };
> 
> then when borad is booting,the dmesg is like this:
> [    4.600035] mdio_bus ff0e0000.ethernet-ffffffff: /amba/ethernet@ff0e0000/phy@0 has invalid PHY address
> [    4.600050] mdio_bus ff0e0000.ethernet-ffffffff: scan phy phy at address 0
> [    4.602076] mdio_bus ff0e0000.ethernet-ffffffff: scan phy phy at address 1
> [    4.603849] mdio_bus ff0e0000.ethernet-ffffffff: scan phy phy at address 2
> [    4.605574] mdio_bus ff0e0000.ethernet-ffffffff: scan phy phy at address 4
> [    4.607312] mdio_bus ff0e0000.ethernet-ffffffff: scan phy phy at address 5
> ...
> [    4.636155] mdio_bus ff0e0000.ethernet-ffffffff: scan phy phy at address 28
> [    4.637335] mdio_bus ff0e0000.ethernet-ffffffff: scan phy phy at address 29
> [    4.638504] mdio_bus ff0e0000.ethernet-ffffffff: scan phy phy at address 30
> [    4.639666] mdio_bus ff0e0000.ethernet-ffffffff: scan phy phy at address 31

For a single PHY without a reg properties, it should do the right
thing. But it will go wrong if there are multiple PHYs without reg
properties. In that case, the break helps.

However, as the comment suggests, you really should have a reg
property.

Please make the commit message better, and then i will give a
reviewed-by.

Thanks
	Andrew