On Tue, Feb 04, 2020 at 11:31:50AM -0800, Stephen Boyd wrote: > We don't need to force IRQF_TRIGGER_HIGH here as the DT or ACPI tables > should take care of this for us. Just use 0 instead so that we use the > flags from the firmware. Also, remove specify dev_name() for the irq > name so that we can get better information in /proc/interrupts about > which device is generating interrupts. > > Cc: Girish Mahadevan > Cc: Dilip Kota > Cc: Alok Chauhan > Cc: Douglas Anderson > Signed-off-by: Stephen Boyd All patches look good, but this one doesn't build because dev is defined in the next patch only. I also can't apply patch 2 before 1, so please rebase and resend. > --- > drivers/i2c/busses/i2c-qcom-geni.c | 4 ++-- > 1 file changed, 2 insertions(+), 2 deletions(-) > > diff --git a/drivers/i2c/busses/i2c-qcom-geni.c b/drivers/i2c/busses/i2c-qcom-geni.c > index 17abf60c94ae..3e13b54ce3f8 100644 > --- a/drivers/i2c/busses/i2c-qcom-geni.c > +++ b/drivers/i2c/busses/i2c-qcom-geni.c > @@ -549,8 +549,8 @@ static int geni_i2c_probe(struct platform_device *pdev) > init_completion(&gi2c->done); > spin_lock_init(&gi2c->lock); > platform_set_drvdata(pdev, gi2c); > - ret = devm_request_irq(&pdev->dev, gi2c->irq, geni_i2c_irq, > - IRQF_TRIGGER_HIGH, "i2c_geni", gi2c); > + ret = devm_request_irq(dev, gi2c->irq, geni_i2c_irq, 0, > + dev_name(&pdev->dev), gi2c); > if (ret) { > dev_err(&pdev->dev, "Request_irq failed:%d: err:%d\n", > gi2c->irq, ret); > -- > Sent by a computer, using git, on the internet >