[PATCH v2 18/19] media: ti-vpe: cal: improve wait for stop-state

[Tomi Valkeinen <tomi.valkeinen@ti.com>]

Sometimes there is a timeout when waiting for the Stop-State.  Testing
shows that sometimes we need to wait more than what the current code
does. It is not clear how long this wait can be, but it is based on how
quickly the sensor provides a valid clock, and how quickly CAL syncs to
it.

Change the code to make it more obvious how long we'll wait, and set a
wider range for usleep_range. Increase the timeout to 750ms.

Signed-off-by: Tomi Valkeinen <tomi.valkeinen@ti.com>
Tested-by: Tomi Valkeinen <tomi.valkeinen@ti.com>
---
 drivers/media/platform/ti-vpe/cal.c | 11 ++++-------
 1 file changed, 4 insertions(+), 7 deletions(-)

diff --git a/drivers/media/platform/ti-vpe/cal.c b/drivers/media/platform/ti-vpe/cal.c
index 0dc7892881e7..0f90078ee8c2 100644
--- a/drivers/media/platform/ti-vpe/cal.c
+++ b/drivers/media/platform/ti-vpe/cal.c
@@ -846,19 +846,16 @@ static void csi2_wait_complexio_reset(struct cal_ctx *ctx)
 
 static void csi2_wait_stop_state(struct cal_ctx *ctx)
 {
-	int i;
+	unsigned long timeout;
 
-	for (i = 0; i < 10; i++) {
+	timeout = jiffies + msecs_to_jiffies(750);
+	while (time_before(jiffies, timeout)) {
 		if (reg_read_field(ctx->dev,
 				   CAL_CSI2_TIMING(ctx->csi2_port),
 				   CAL_CSI2_TIMING_FORCE_RX_MODE_IO1_MASK) == 0)
 			break;
-		usleep_range(1000, 1100);
+		usleep_range(500, 5000);
 	}
-	ctx_dbg(3, ctx, "CAL_CSI2_TIMING(%d) = 0x%08x Stop State Reached %s\n",
-		ctx->csi2_port,
-		reg_read(ctx->dev, CAL_CSI2_TIMING(ctx->csi2_port)),
-		(i >= 10) ? "(timeout)" : "");
 
 	if (reg_read_field(ctx->dev, CAL_CSI2_TIMING(ctx->csi2_port),
 			   CAL_CSI2_TIMING_FORCE_RX_MODE_IO1_MASK) != 0)
-- 
Texas Instruments Finland Oy, Porkkalankatu 22, 00180 Helsinki.
Y-tunnus/Business ID: 0615521-4. Kotipaikka/Domicile: Helsinki