[PATCH v4 02/10] net: eth: altera: set rx and tx ring size before init_dma call

["Ooi, Joyce" <joyce.ooi@intel.com>]

From: Dalon Westergreen <dalon.westergreen@intel.com>

It is more appropriate to set the rx and tx ring size before calling
the init function for the dma.

Signed-off-by: Dalon Westergreen <dalon.westergreen@intel.com>
Signed-off-by: Joyce Ooi <joyce.ooi@intel.com>
---
v2: no change
v3: no change
v4: no change
---
 drivers/net/ethernet/altera/altera_tse_main.c | 6 ++++--
 1 file changed, 4 insertions(+), 2 deletions(-)

diff --git a/drivers/net/ethernet/altera/altera_tse_main.c b/drivers/net/ethernet/altera/altera_tse_main.c
index ec2b36e05c3f..a3749ffdcac9 100644
--- a/drivers/net/ethernet/altera/altera_tse_main.c
+++ b/drivers/net/ethernet/altera/altera_tse_main.c
@@ -1154,6 +1154,10 @@ static int tse_open(struct net_device *dev)
 	int i;
 	unsigned long int flags;
 
+	/* set tx and rx ring size */
+	priv->rx_ring_size = dma_rx_num;
+	priv->tx_ring_size = dma_tx_num;
+
 	/* Reset and configure TSE MAC and probe associated PHY */
 	ret = priv->dmaops->init_dma(priv);
 	if (ret != 0) {
@@ -1196,8 +1200,6 @@ static int tse_open(struct net_device *dev)
 	priv->dmaops->reset_dma(priv);
 
 	/* Create and initialize the TX/RX descriptors chains. */
-	priv->rx_ring_size = dma_rx_num;
-	priv->tx_ring_size = dma_tx_num;
 	ret = alloc_init_skbufs(priv);
 	if (ret) {
 		netdev_err(dev, "DMA descriptors initialization failed\n");
-- 
2.13.0