[PATCH v5 13/20] qga/qapi-schema.json: Add some headings

[Peter Maydell <peter.maydell@linaro.org>]

Add some section headings to the QGA json; this is purely so that we
have some H1 headings, as otherwise each command ends up being
visible in the interop/ manual's table of contents.  In an ideal
world there might be a proper 'Introduction' section the way there is
in qapi/qapi-schema.json.

Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
---
 qga/qapi-schema.json | 12 ++++++++----
 1 file changed, 8 insertions(+), 4 deletions(-)

diff --git a/qga/qapi-schema.json b/qga/qapi-schema.json
index b1e9ed836de..401467860a7 100644
--- a/qga/qapi-schema.json
+++ b/qga/qapi-schema.json
@@ -2,14 +2,18 @@
 # vim: filetype=python
 
 ##
-#
-# General note concerning the use of guest agent interfaces:
-#
+# = General note concerning the use of guest agent interfaces
+##
+
+##
 # "unsupported" is a higher-level error than the errors that individual
 # commands might document. The caller should always be prepared to receive
 # QERR_UNSUPPORTED, even if the given command doesn't specify it, or doesn't
 # document any failure mode at all.
-#
+##
+
+##
+# = QEMU guest agent protocol commands and structs
 ##
 
 { 'pragma': { 'doc-required': true } }
-- 
2.20.1