Re: [PATCH] PCI: qcom: Make sure PCIe is reset before init for rev 2.1.0

[Lorenzo Pieralisi <lorenzo.pieralisi@arm.com>]

On Tue, Sep 01, 2020 at 02:49:54PM +0200, Ansuel Smith wrote:
> Qsdk U-Boot can incorrectly leave the PCIe interface in an undefined
> state if bootm command is used instead of bootipq. This is caused by the
> not deinit of PCIe when bootm is called. Reset the PCIe before init
> anyway to fix this U-Boot bug.
> 
> Signed-off-by: Ansuel Smith <ansuelsmth@gmail.com>
> Fixes: 82a823833f4e ("PCI: qcom: Add Qualcomm PCIe controller driver")
> Cc: stable@vger.kernel.org # v4.19+
> ---
>  drivers/pci/controller/dwc/pcie-qcom.c | 13 +++++++++++++
>  1 file changed, 13 insertions(+)

Applied to pci/qcom, thanks.

Lorenzo

> diff --git a/drivers/pci/controller/dwc/pcie-qcom.c b/drivers/pci/controller/dwc/pcie-qcom.c
> index 3aac77a295ba..82336bbaf8dc 100644
> --- a/drivers/pci/controller/dwc/pcie-qcom.c
> +++ b/drivers/pci/controller/dwc/pcie-qcom.c
> @@ -302,6 +302,9 @@ static void qcom_pcie_deinit_2_1_0(struct qcom_pcie *pcie)
>  	reset_control_assert(res->por_reset);
>  	reset_control_assert(res->ext_reset);
>  	reset_control_assert(res->phy_reset);
> +
> +	writel(1, pcie->parf + PCIE20_PARF_PHY_CTRL);
> +
>  	regulator_bulk_disable(ARRAY_SIZE(res->supplies), res->supplies);
>  }
>  
> @@ -314,6 +317,16 @@ static int qcom_pcie_init_2_1_0(struct qcom_pcie *pcie)
>  	u32 val;
>  	int ret;
>  
> +	/* reset the PCIe interface as uboot can leave it undefined state */
> +	reset_control_assert(res->pci_reset);
> +	reset_control_assert(res->axi_reset);
> +	reset_control_assert(res->ahb_reset);
> +	reset_control_assert(res->por_reset);
> +	reset_control_assert(res->ext_reset);
> +	reset_control_assert(res->phy_reset);
> +
> +	writel(1, pcie->parf + PCIE20_PARF_PHY_CTRL);
> +
>  	ret = regulator_bulk_enable(ARRAY_SIZE(res->supplies), res->supplies);
>  	if (ret < 0) {
>  		dev_err(dev, "cannot enable regulators\n");
> -- 
> 2.27.0
>