On Fri, Dec 11, 2020 at 10:28:35AM +0100, Lino Sanfilippo wrote: > Hi Uwe, > > > Gesendet: Donnerstag, 10. Dezember 2020 um 12:43 Uhr > > Von: "Uwe Kleine-König" > > An: "Lino Sanfilippo" > > Cc: thierry.reding@gmail.com, lee.jones@linaro.org, nsaenzjulienne@suse.de, f.fainelli@gmail.com, rjui@broadcom.com, sean@mess.org, sbranden@broadcom.com, bcm-kernel-feedback-list@broadcom.com, linux-pwm@vger.kernel.org, linux-rpi-kernel@lists.infradead.org, linux-arm-kernel@lists.infradead.org, linux-kernel@vger.kernel.org > > Betreff: Re: [PATCH v3] pwm: bcm2835: Support apply function for atomic configuration > > > > > Side note: I'm a bit surprised about the output of > > > > b4 diff 1607464905-16630-1-git-send-email-LinoSanfilippo@gmx.de > > > > This is probably due to the fact that compared to v3 you also rebased. > > Still the diff is quite big. > > You are right, I made a rebase before I created the last patch, sorry for the confusion this caused. > Anyway, thanks for the review(s)! You did everything good enough. (To further improve, you could use git-format-patch's --base option and mention a rebase in the series' changelog; note this is quite high level critic.) This was more me wondering the output is not easier to use. (And note I also showed the wrong commandline, but that doesn't resolve the issue. The right command is: b4 diff 1607546905-20549-1-git-send-email-LinoSanfilippo@gmx.de .) Best regards Uwe -- Pengutronix e.K. | Uwe Kleine-König | Industrial Linux Solutions | https://www.pengutronix.de/ |