Re: [PATCH v2 02/18] media: i2c: rdacm20: Enable noise immunity

[Jacopo Mondi <jacopo@jmondi.org>]

Hi Laurent,

On Mon, Mar 15, 2021 at 11:37:26PM +0200, Laurent Pinchart wrote:
> Hi Jacopo,
>
> Thank you for the patch.
>
> On Mon, Mar 15, 2021 at 02:14:56PM +0100, Jacopo Mondi wrote:
> > Enable the noise immunity threshold at the end of the rdacm20
> > initialization routine.
> >
> > The rdacm20 camera module has been so far tested with a startup
> > delay that allowed the embedded MCU to program the serializer. If
> > the initialization routine is run before the MCU programs the
> > serializer and the image sensor and their addresses gets changed
> > by the rdacm20 driver it is required to manually enable the noise
> > immunity threshold to make the communication on the control channel
> > more reliable.
>
> I'm still worried by the race with the MCU. Any update on dumping the
> MCU configuration to check what it initializes ?
>

Not yet, you're right ...

I mainly focused on testing with rdacm21, what if I strip the rdacm20
changes out from this series ? I will have to keep the init()
operation introduction to maintain compatibility with max9286 changes,
and in case of no regressions, we can keep the 8 seconds delay in the
.dtsi. However it will break upstream support on Eagle for rdacm20 as
we don't have a regulator where to insert the startup delay there, and
a downstream patch that waits for 8 seconds in the deserializer driver
should be used instead...

> > Reviewed-by: Kieran Bingham <kieran.bingham+renesas@ideasonboard.com>
> > Signed-off-by: Jacopo Mondi <jacopo+renesas@jmondi.org>
> > ---
> >  drivers/media/i2c/rdacm20.c | 8 +++++++-
> >  1 file changed, 7 insertions(+), 1 deletion(-)
> >
> > diff --git a/drivers/media/i2c/rdacm20.c b/drivers/media/i2c/rdacm20.c
> > index 90eb73f0e6e9..f7fd5ae955d0 100644
> > --- a/drivers/media/i2c/rdacm20.c
> > +++ b/drivers/media/i2c/rdacm20.c
> > @@ -541,7 +541,13 @@ static int rdacm20_initialize(struct rdacm20_device *dev)
> >
> >  	dev_info(dev->dev, "Identified MAX9271 + OV10635 device\n");
> >
> > -	return 0;
> > +	/*
> > +	 * Set reverse channel high threshold to increase noise immunity.
> > +	 *
> > +	 * This should be compensated by increasing the reverse channel
> > +	 * amplitude on the remote deserializer side.
> > +	 */
> > +	return max9271_set_high_threshold(&dev->serializer, true);
> >  }
> >
> >  static int rdacm20_probe(struct i2c_client *client)
>
> --
> Regards,
>
> Laurent Pinchart