[PATCH 15/28] media: ti-vpe: cal: remove wait when stopping camerarx

[Tomi Valkeinen <tomi.valkeinen@ideasonboard.com>]

Asserting ComplexIO reset seems to affect the HW (ie. asserting reset
will break an active capture), but the RESET_DONE bit never changes to
"reset is ongoing" state. Thus we always get a timeout.

Drop the wait, as it seems to achieve nothing.

Signed-off-by: Tomi Valkeinen <tomi.valkeinen@ideasonboard.com>
---
 drivers/media/platform/ti-vpe/cal-camerarx.c | 15 ++-------------
 1 file changed, 2 insertions(+), 13 deletions(-)

diff --git a/drivers/media/platform/ti-vpe/cal-camerarx.c b/drivers/media/platform/ti-vpe/cal-camerarx.c
index 0354f311c5d2..245c601b992c 100644
--- a/drivers/media/platform/ti-vpe/cal-camerarx.c
+++ b/drivers/media/platform/ti-vpe/cal-camerarx.c
@@ -405,7 +405,6 @@ static int cal_camerarx_start(struct cal_camerarx *phy)
 
 static void cal_camerarx_stop(struct cal_camerarx *phy)
 {
-	unsigned int i;
 	int ret;
 
 	cal_camerarx_ppi_disable(phy);
@@ -419,19 +418,9 @@ static void cal_camerarx_stop(struct cal_camerarx *phy)
 			CAL_CSI2_COMPLEXIO_CFG_RESET_CTRL,
 			CAL_CSI2_COMPLEXIO_CFG_RESET_CTRL_MASK);
 
-	/* Wait for power down completion */
-	for (i = 0; i < 10; i++) {
-		if (cal_read_field(phy->cal,
-				   CAL_CSI2_COMPLEXIO_CFG(phy->instance),
-				   CAL_CSI2_COMPLEXIO_CFG_RESET_DONE_MASK) ==
-		    CAL_CSI2_COMPLEXIO_CFG_RESET_DONE_RESETONGOING)
-			break;
-		usleep_range(1000, 1100);
-	}
-	phy_dbg(3, phy, "CAL_CSI2_COMPLEXIO_CFG(%d) = 0x%08x Complex IO in Reset (%d) %s\n",
+	phy_dbg(3, phy, "CAL_CSI2_COMPLEXIO_CFG(%d) = 0x%08x Complex IO in Reset\n",
 		phy->instance,
-		cal_read(phy->cal, CAL_CSI2_COMPLEXIO_CFG(phy->instance)), i,
-		(i >= 10) ? "(timeout)" : "");
+		cal_read(phy->cal, CAL_CSI2_COMPLEXIO_CFG(phy->instance)));
 
 	/* Disable the phy */
 	cal_camerarx_disable(phy);
-- 
2.25.1