Hello Oliver,

I was wondering what the RX, TX and echo semantics on vxcan interfaces
should be.

I have started a "cangen" in one namespace and a "candump" in other.

The "candump" in the receiving namespace shows the CAN frames as "TX"
and in the sending namespace the CAN frames don't show up in a "candump"
at all. Is this intentional? If so what's the idea behind this and is
this documented?

I'm adding "cangw" to the mix and see what happens....

regards,
Marc

-- 
Pengutronix e.K.                 | Marc Kleine-Budde           |
Embedded Linux                   | https://www.pengutronix.de  |
Vertretung West/Dortmund         | Phone: +49-231-2826-924     |
Amtsgericht Hildesheim, HRA 2686 | Fax:   +49-5121-206917-5555 |