On Sun 2021-09-12 13:54:26, Donovan Drews wrote:
> Just bumping this patch in case it was overlooked.

Please don't. Patches are not usually merged during the -rc1 time.

Best regards,
								Pavel

> On Sat, Aug 28, 2021 at 2:43 PM DonDrews <donovancarldrews@gmail.com> wrote:
> 
> >         Fixes an issue where previously 0 is used as a sentinel when
> >         moving device tree configuration into the bank enable mask. This
> >         prevented the first LED from being added to bank control.
> >
> > Signed-off-by: DonDrews <donovancarldrews@gmail.com>
> > ---
> >  drivers/leds/leds-lp50xx.c | 10 ++++------
> >  1 file changed, 4 insertions(+), 6 deletions(-)
> >
> > diff --git a/drivers/leds/leds-lp50xx.c b/drivers/leds/leds-lp50xx.c
> > index 401df1e2e05d..45f56caea182 100644
> > --- a/drivers/leds/leds-lp50xx.c
> > +++ b/drivers/leds/leds-lp50xx.c
> > @@ -347,17 +347,15 @@ static int lp50xx_brightness_set(struct led_classdev
> > *cdev,
> >         return ret;
> >  }
> >
> > -static int lp50xx_set_banks(struct lp50xx *priv, u32 led_banks[])
> > +static int lp50xx_set_banks(struct lp50xx *priv, u32 led_banks[], int
> > num_leds)
> >  {
> >         u8 led_config_lo, led_config_hi;
> >         u32 bank_enable_mask = 0;
> >         int ret;
> >         int i;
> >
> > -       for (i = 0; i < priv->chip_info->max_modules; i++) {
> > -               if (led_banks[i])
> > -                       bank_enable_mask |= (1 << led_banks[i]);
> > -       }
> > +       for (i = 0; i < num_leds; i++)
> > +               bank_enable_mask |= (1 << led_banks[i]);
> >
> >         led_config_lo = bank_enable_mask;
> >         led_config_hi = bank_enable_mask >> 8;
> > @@ -413,7 +411,7 @@ static int lp50xx_probe_leds(struct fwnode_handle
> > *child, struct lp50xx *priv,
> >                         return ret;
> >                 }
> >
> > -               ret = lp50xx_set_banks(priv, led_banks);
> > +               ret = lp50xx_set_banks(priv, led_banks, num_leds);
> >                 if (ret) {
> >                         dev_err(priv->dev, "Cannot setup banked LEDs\n");
> >                         return ret;
> > --
> > 2.17.1
> >
> >

-- 
http://www.livejournal.com/~pavelmachek