[PATCH 5.15 regression fix] Bluetooth: hci_h5: Fix (runtime)suspend issues on RTL8723BS HCIs

[Hans de Goede <hdegoede@redhat.com>]

The recently added H5_WAKEUP_DISABLE h5->flags flag gets checked in
h5_btrtl_open(), but it gets set in h5_serdev_probe() *after*
calling  hci_uart_register_device() and thus after h5_btrtl_open()
is called, set this flag earlier.

Also on devices where suspend/resume involves fully re-probing the HCI,
runtime-pm suspend should not be used, make the runtime-pm setup
conditional on the H5_WAKEUP_DISABLE flag too.

This fixes the HCI being removed and then re-added every 10 seconds
because it was being reprobed as soon as it was runtime-suspended.

Cc: Archie Pusaka <apusaka@chromium.org>
Fixes: 66f077dde749 ("Bluetooth: hci_h5: add WAKEUP_DISABLE flag")
Fixes: d9dd833cf6d2 ("Bluetooth: hci_h5: Add runtime suspend")
Signed-off-by: Hans de Goede <hdegoede@redhat.com>
---
 drivers/bluetooth/hci_h5.c | 20 +++++++++++---------
 1 file changed, 11 insertions(+), 9 deletions(-)

diff --git a/drivers/bluetooth/hci_h5.c b/drivers/bluetooth/hci_h5.c
index 0c0dedece59c..59b712742d33 100644
--- a/drivers/bluetooth/hci_h5.c
+++ b/drivers/bluetooth/hci_h5.c
@@ -846,6 +846,8 @@ static int h5_serdev_probe(struct serdev_device *serdev)
 		h5->vnd = data->vnd;
 	}
 
+	if (data->driver_info & H5_INFO_WAKEUP_DISABLE)
+		set_bit(H5_WAKEUP_DISABLE, &h5->flags);
 
 	h5->enable_gpio = devm_gpiod_get_optional(dev, "enable", GPIOD_OUT_LOW);
 	if (IS_ERR(h5->enable_gpio))
@@ -860,9 +862,6 @@ static int h5_serdev_probe(struct serdev_device *serdev)
 	if (err)
 		return err;
 
-	if (data->driver_info & H5_INFO_WAKEUP_DISABLE)
-		set_bit(H5_WAKEUP_DISABLE, &h5->flags);
-
 	return 0;
 }
 
@@ -962,11 +961,13 @@ static void h5_btrtl_open(struct h5 *h5)
 	serdev_device_set_parity(h5->hu->serdev, SERDEV_PARITY_EVEN);
 	serdev_device_set_baudrate(h5->hu->serdev, 115200);
 
-	pm_runtime_set_active(&h5->hu->serdev->dev);
-	pm_runtime_use_autosuspend(&h5->hu->serdev->dev);
-	pm_runtime_set_autosuspend_delay(&h5->hu->serdev->dev,
-					 SUSPEND_TIMEOUT_MS);
-	pm_runtime_enable(&h5->hu->serdev->dev);
+	if (!test_bit(H5_WAKEUP_DISABLE, &h5->flags)) {
+		pm_runtime_set_active(&h5->hu->serdev->dev);
+		pm_runtime_use_autosuspend(&h5->hu->serdev->dev);
+		pm_runtime_set_autosuspend_delay(&h5->hu->serdev->dev,
+						 SUSPEND_TIMEOUT_MS);
+		pm_runtime_enable(&h5->hu->serdev->dev);
+	}
 
 	/* The controller needs up to 500ms to wakeup */
 	gpiod_set_value_cansleep(h5->enable_gpio, 1);
@@ -976,7 +977,8 @@ static void h5_btrtl_open(struct h5 *h5)
 
 static void h5_btrtl_close(struct h5 *h5)
 {
-	pm_runtime_disable(&h5->hu->serdev->dev);
+	if (!test_bit(H5_WAKEUP_DISABLE, &h5->flags))
+		pm_runtime_disable(&h5->hu->serdev->dev);
 
 	gpiod_set_value_cansleep(h5->device_wake_gpio, 0);
 	gpiod_set_value_cansleep(h5->enable_gpio, 0);
-- 
2.31.1