Hello,

On Mon, Oct 11, 2021 at 03:27:41PM +0200, Uwe Kleine-König wrote:
> this series is part of my new quest to make spi remove callbacks return
> void. Today they return an int, but the only result of returning a
> non-zero value is a warning message. So it's a bad idea to return an
> error code in the expectation that not freeing some resources is ok
> then. The same holds true for i2c and platform devices which benefit en
> passant for a few drivers.
> 
> The patches in this series address some of the spi drivers that might
> return non-zero and adapt them accordingly to return zero instead. For
> most drivers it's just about not hiding the fact that they already
> return zero.
> 
> Given that there are quite some more patches of this type to create
> before I can change the spi remove callback, I suggest the respecive
> subsystem maintainers pick up these patches. There are no
> interdependencies in this series.
> 
> Uwe Kleine-König (13):
>   drm/panel: s6e63m0: Make s6e63m0_remove() return void
>   hwmon: adt7x10: Make adt7x10_remove() return void
>   hwmon: max31722: Warn about failure to put device in stand-by in
>     .remove()
>   input: adxl34xx: Make adxl34x_remove() return void
>   input: touchscreen: tsc200x: Make tsc200x_remove() return void
>   media: cxd2880: Eliminate dead code
>   mfd: mc13xxx: Make mc13xxx_common_exit() return void
>   mfd: stmpe: Make stmpe_remove() return void
>   mfd: tps65912: Make tps65912_device_exit() return void
>   serial: max310x: Make max310x_remove() return void
>   serial: sc16is7xx: Make sc16is7xx_remove() return void
>   staging: fbtft: Make fbtft_remove_common() return void
>   tpm: st33zp24: Make st33zp24_remove() return void

I thought I would be a good enough programmer to not need build tests.
Obviously I was wrong and introduced build problems with the following
patches:

	input: touchscreen: tsc200x: Make tsc200x_remove() return void
	mfd: mc13xxx: Make mc13xxx_common_exit() return void
	serial: max310x: Make max310x_remove() return void
	serial: sc16is7xx: Make sc16is7xx_remove() return void

Please don't apply these (unless you also fix the trivial problems in
them). I will prepare a v2 soon.

Best regards and sorry for the inconvenience,
Uwe

-- 
Pengutronix e.K.                           | Uwe Kleine-König            |
Industrial Linux Solutions                 | https://www.pengutronix.de/ |