[PATCH] cmd: pxe_utils: Check fdtcontroladdr in label_boot

[Peter Hoyes <peter.hoyes@arm.com>]

From: Peter Hoyes <Peter.Hoyes@arm.com>

If using OF_CONTROL, fdtcontroladdr is set to the fdt used to configure
U-Boot. When using PXE, if no fdt is defined in the menu file, and
there is no fdt at fdt_addr, add fall back on fdtcontroladdr too.

We are developing board support for the Armv8r64 FVP using
config_distro_bootcmd. We are also using OF_BOARD and would like the
PXE boot option to default to the fdt provided by board_fdt_blob_setup.

Signed-off-by: Peter Hoyes <Peter.Hoyes@arm.com>
---
 cmd/pxe_utils.c | 8 +++++++-
 1 file changed, 7 insertions(+), 1 deletion(-)

diff --git a/cmd/pxe_utils.c b/cmd/pxe_utils.c
index 067c24e5ff..8f8e69ca97 100644
--- a/cmd/pxe_utils.c
+++ b/cmd/pxe_utils.c
@@ -556,7 +556,10 @@ static int label_boot(struct cmd_tbl *cmdtp, struct pxe_label *label)
 	 * Scenario 2: If there is an fdt_addr specified, pass it along to
 	 * bootm, and adjust argc appropriately.
 	 *
-	 * Scenario 3: fdt blob is not available.
+	 * Scenario 3: If there is an fdtcontroladdr specified, pass it along to
+	 * bootm, and adjust argc appropriately.
+	 *
+	 * Scenario 4: fdt blob is not available.
 	 */
 	bootm_argv[3] = env_get("fdt_addr_r");
 
@@ -646,6 +649,9 @@ static int label_boot(struct cmd_tbl *cmdtp, struct pxe_label *label)
 	if (!bootm_argv[3])
 		bootm_argv[3] = env_get("fdt_addr");
 
+	if (!bootm_argv[3])
+		bootm_argv[3] = env_get("fdtcontroladdr");
+
 	if (bootm_argv[3]) {
 		if (!bootm_argv[2])
 			bootm_argv[2] = "-";
-- 
2.25.1