[PATCH] examples/ipsec-secgw: fix default flow rule creation

From: Nithin Dabilpuram <ndabilpuram@marvell.com>
To: Radu Nicolau <radu.nicolau@intel.com>, Akhil Goyal <gakhil@marvell.com>
Cc: <dev@dpdk.org>, <jerinj@marvell.com>,
	Nithin Dabilpuram <ndabilpuram@marvell.com>,
	<adwivedi@marvell.com>, <stable@dpdk.org>
Subject: [PATCH] examples/ipsec-secgw: fix default flow rule creation
Date: Fri, 17 Dec 2021 18:14:51 +0530	[thread overview]
Message-ID: <20211217124451.7464-1-ndabilpuram@marvell.com> (raw)

Fix default flow rule to create after ethdev start to align
wit RTE flow spec.

Fixes: 513f192b5fd4 ("examples/ipsec-secgw: add default flow for inline Rx")
Cc: adwivedi@marvell.com
Cc: stable@dpdk.org

Signed-off-by: Nithin Dabilpuram <ndabilpuram@marvell.com>
---
 examples/ipsec-secgw/ipsec-secgw.c | 7 ++++---
 1 file changed, 4 insertions(+), 3 deletions(-)

diff --git a/examples/ipsec-secgw/ipsec-secgw.c b/examples/ipsec-secgw/ipsec-secgw.c
index bf3dbf6..8e2aa46 100644
--- a/examples/ipsec-secgw/ipsec-secgw.c
+++ b/examples/ipsec-secgw/ipsec-secgw.c
@@ -3379,13 +3379,14 @@ main(int32_t argc, char **argv)
 		if ((enabled_port_mask & (1 << portid)) == 0)
 			continue;
 
-		/* Create flow before starting the device */
-		create_default_ipsec_flow(portid, req_rx_offloads[portid]);
-
 		ret = rte_eth_dev_start(portid);
 		if (ret < 0)
 			rte_exit(EXIT_FAILURE, "rte_eth_dev_start: "
 					"err=%d, port=%d\n", ret, portid);
+
+		/* Create flow after starting the device */
+		create_default_ipsec_flow(portid, req_rx_offloads[portid]);
+
 		/*
 		 * If enabled, put device in promiscuous mode.
 		 * This allows IO forwarding mode to forward packets
-- 
2.8.4

