[PATCH V2 2/4] net/bonding: fix non-terminable while loop

["Min Hu (Connor)" <humin29@huawei.com>]

From: Huisong Li <lihuisong@huawei.com>

All slaves will be stopped and removed when closing a bonded port. But the
while loop can not stop if both rte_eth_dev_stop and
rte_eth_bond_slave_remove fail to run.

Fixes: fb0379bc5db3 ("net/bonding: check stop call status")
Cc: stable@dpdk.org

Signed-off-by: Huisong Li <lihuisong@huawei.com>
Signed-off-by: Min Hu (Connor) <humin29@huawei.com>
---
 drivers/net/bonding/rte_eth_bond_pmd.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/drivers/net/bonding/rte_eth_bond_pmd.c b/drivers/net/bonding/rte_eth_bond_pmd.c
index 469dc71170..00d4deda44 100644
--- a/drivers/net/bonding/rte_eth_bond_pmd.c
+++ b/drivers/net/bonding/rte_eth_bond_pmd.c
@@ -2149,13 +2149,14 @@ bond_ethdev_close(struct rte_eth_dev *dev)
 		return 0;
 
 	RTE_BOND_LOG(INFO, "Closing bonded device %s", dev->device->name);
-	while (internals->slave_count != skipped) {
+	while (skipped < internals->slave_count) {
 		uint16_t port_id = internals->slaves[skipped].port_id;
 
 		if (rte_eth_dev_stop(port_id) != 0) {
 			RTE_BOND_LOG(ERR, "Failed to stop device on port %u",
 				     port_id);
 			skipped++;
+			continue;
 		}
 
 		if (rte_eth_bond_slave_remove(bond_port_id, port_id) != 0) {
-- 
2.33.0