[PATCH v7 01/11] arm64: dts: qcom: sdm630: disable dsi0/dsi0_phy by default

[Dmitry Baryshkov <dmitry.baryshkov@linaro.org>]

Follow the typical practice and keep DSI0/DSI0 PHY disabled by default.
They should be enabled in the board DT files. No existing boards use
them at this moment.

Suggested-by: Marijn Suijten <marijn.suijten@somainline.org>
Reviewed-by: Konrad Dybcio <konrad.dybcio@somainline.org>
Reviewed-by: Marijn Suijten <marijn.suijten@somainline.org>
Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
---
 arch/arm64/boot/dts/qcom/sdm630.dtsi | 3 +++
 1 file changed, 3 insertions(+)

diff --git a/arch/arm64/boot/dts/qcom/sdm630.dtsi b/arch/arm64/boot/dts/qcom/sdm630.dtsi
index b72e8e6c52f3..80d5eae9bc75 100644
--- a/arch/arm64/boot/dts/qcom/sdm630.dtsi
+++ b/arch/arm64/boot/dts/qcom/sdm630.dtsi
@@ -1563,6 +1563,8 @@ dsi0: dsi@c994000 {
 				phys = <&dsi0_phy>;
 				phy-names = "dsi";
 
+				status = "disabled";
+
 				ports {
 					#address-cells = <1>;
 					#size-cells = <0>;
@@ -1596,6 +1598,7 @@ dsi0_phy: dsi-phy@c994400 {
 
 				clocks = <&mmcc MDSS_AHB_CLK>, <&xo_board>;
 				clock-names = "iface", "ref";
+				status = "disabled";
 			};
 		};
 
-- 
2.35.1