[PATCH v5 5/5] usb: dwc3: gadget: Submit endxfer command if delayed during disconnect

[Wesley Cheng <quic_wcheng@quicinc.com>]

During a cable disconnect sequence, if ep0state is not in the SETUP phase,
then nothing will trigger any pending end transfer commands.  Force
stopping of any pending SETUP transaction, and move back to the SETUP
phase.

Reviewed-by: Thinh Nguyen <Thinh.Nguyen@synopsys.com>
Signed-off-by: Wesley Cheng <quic_wcheng@quicinc.com>
---
 drivers/usb/dwc3/gadget.c | 13 ++++++++++++-
 1 file changed, 12 insertions(+), 1 deletion(-)

diff --git a/drivers/usb/dwc3/gadget.c b/drivers/usb/dwc3/gadget.c
index 4721561e4ba5..515980bf61e2 100644
--- a/drivers/usb/dwc3/gadget.c
+++ b/drivers/usb/dwc3/gadget.c
@@ -3776,13 +3776,24 @@ static void dwc3_gadget_disconnect_interrupt(struct dwc3 *dwc)
 	reg &= ~DWC3_DCTL_INITU2ENA;
 	dwc3_gadget_dctl_write_safe(dwc, reg);
 
+	dwc->connected = false;
+
 	dwc3_disconnect_gadget(dwc);
 
 	dwc->gadget->speed = USB_SPEED_UNKNOWN;
 	dwc->setup_packet_pending = false;
 	usb_gadget_set_state(dwc->gadget, USB_STATE_NOTATTACHED);
 
-	dwc->connected = false;
+	if (dwc->ep0state != EP0_SETUP_PHASE) {
+		unsigned int    dir;
+
+		dir = !!dwc->ep0_expect_in;
+		if (dwc->ep0state == EP0_DATA_PHASE)
+			dwc3_ep0_end_control_data(dwc, dwc->eps[dir]);
+		else
+			dwc3_ep0_end_control_data(dwc, dwc->eps[!dir]);
+		dwc3_ep0_stall_and_restart(dwc);
+	}
 }
 
 static void dwc3_gadget_reset_interrupt(struct dwc3 *dwc)