On Mon, Aug 08, 2022 at 09:46:05PM +0930, Joel Stanley wrote:

> From: Samuel Mendoza-Jonas <sam@mendozajonas.com>
> 
> Update the ftgmac100 driver to support NC-SI instead of an mdio phy
> where available. This is a common setup for Aspeed AST2x00 platforms.
> 
> NC-SI mode is determined from the device-tree if either phy-mode sets it
> or the use-ncsi property exists. If set then normal mdio setup is
> skipped in favour of the NC-SI phy.
> 
> Signed-off-by: Samuel Mendoza-Jonas <sam@mendozajonas.com>
> Signed-off-by: Joel Stanley <joel@jms.id.au>
> Reviewed-by: Cédric Le Goater <clg@kaod.org>
> Reviewed-by: Ramon Fried <rfried.dev@gmail.com>

Applied to u-boot/master, thanks!

-- 
Tom