Hello, On Wed, Oct 26, 2022 at 04:17:55PM +0200, Uwe Kleine-König wrote: > On Wed, Oct 26, 2022 at 11:13:04AM +0100, Jon Hunter wrote: > > For the case where dev_pm_opp_set_rate() is called to set the PWM clock > > rate, the requested rate is calculated as ... > > > > required_clk_rate = (NSEC_PER_SEC / period_ns) << PWM_DUTY_WIDTH; > > > > The above calculation may lead to rounding errors because the > > NSEC_PER_SEC is divided by 'period_ns' before applying the > > PWM_DUTY_WIDTH multiplication factor. For example, if the period is > > 45334ns, the above calculation yields a rate of 5646848Hz instead of > > 5646976Hz. Fix this by applying the multiplication factor before > > dividing and using the DIV_ROUND_UP macro which yields the expected > > result of 5646976Hz. > > > > Fixes: 1d7796bdb63a ("pwm: tegra: Support dynamic clock frequency configuration") > > Signed-off-by: Jon Hunter > > --- > > drivers/pwm/pwm-tegra.c | 4 ++-- > > 1 file changed, 2 insertions(+), 2 deletions(-) > > > > diff --git a/drivers/pwm/pwm-tegra.c b/drivers/pwm/pwm-tegra.c > > index dad9978c9186..8a33c500f93b 100644 > > --- a/drivers/pwm/pwm-tegra.c > > +++ b/drivers/pwm/pwm-tegra.c > > @@ -145,8 +145,8 @@ static int tegra_pwm_config(struct pwm_chip *chip, struct pwm_device *pwm, > > * source clock rate as required_clk_rate, PWM controller will > > * be able to configure the requested period. > > */ > > - required_clk_rate = > > - (NSEC_PER_SEC / period_ns) << PWM_DUTY_WIDTH; > > + required_clk_rate = DIV_ROUND_UP_ULL((NSEC_PER_SEC << PWM_DUTY_WIDTH), > > + period_ns); > > This also has the nice side effect that required_clk_rate doesn't become > zero any more for big period_ns values. > > Reviewed-by: Uwe Kleine-König I just noticed you could drop a pair of parenthesis in the first parameter to DIV_ROUND_UP_ULL. Best regards Uwe -- Pengutronix e.K. | Uwe Kleine-König | Industrial Linux Solutions | https://www.pengutronix.de/ |