On January 22, 2015 07:58, Lee Jones wrote: > On Wed, 21 Jan 2015, Jonathan Cameron wrote: > > > > > > > On 21 January 2015 16:52:50 GMT+00:00, Sebastian Reichel > wrote: > > >Hi, > > > > > >On Wed, Jan 21, 2015 at 03:46:25PM +0000, Adam Thomson wrote: > > >> This patch set adds initial support for the Dialog DA9150 Integrated > > >Charger & > > >> Fuel-Gauge IC. The device also provides GPIO and GPADC functionality. > > >> > > >> In this patch set the following is provided: > > >> - MFD Core support and DT bindings documentation. > > >> - IIO GPADC support and DT bindings documentation. > > >> - Power Supply Charger support and DT bindings documentation. > > >> - Update to MAINTAINERS file to add DA9150 files to Dialog support > > >list. > > >> > > >> To keep patch submission from being too large, support for GPIO and > > >Fuel-Gauge > > >> will come after initial support patches are accepted. > > >> > > >> This patch set is baselined against the v3.19-rc5 kernel version. > > >> > > >> Changes in v6: > > >> - For GPADC driver, Use lower case extended names for IIO GPADC > > >channels, and > > >> remove extended names for GPIO related channels. > > >> - For charger driver, revert to no devm IRQ request/free functions as > > >ordering > > >> is important, and probe failure scenario was not being correctly > > >covered. A > > >> helper function for free IRQs has been added to make code cleaner. > > > > > >Probably a devm_ variant of power_supply_register should be created, > > >but for now this is ok for me. > > > > > >Jonathan, Lee: I assume you are ok with the whole patchset going > > >through the power supply subsystem? > > > > > Fine by me if either power supply or MFD. > > I am, but there is a lot of MFD code here, so I'd like to take it in > as well. I'd like a tagged pull-request from Sebastian. Hi Sebastien, Just a quick one to see what the status is on this patch set? Just interested as to when it'll be pulled in. Thanks Adam {.n++%ݶw{.n+{G{ayʇڙ,jfhz_(階ݢj"mG?&~iOzv^m ?I