[U-Boot] [u-boot PATCH v3 7/8] ARM: k2g: setup PRU ethernet MAC addresses

[Lokesh Vutla <lokeshvutla@ti.com>]

On 2/6/2017 3:06 PM, Roger Quadros wrote:
> PRU ethernet MAC address range is present in the
> board EEPROM. Parse it and setup eth?addr
> environment variables.
> 
> Signed-off-by: Roger Quadros <rogerq@ti.com>
> Reviewed-by: Lokesh Vutla <lokeshvutla@ti.com>
> ---
>  board/ti/ks2_evm/board_k2g.c | 19 +++++++++++++++++++
>  1 file changed, 19 insertions(+)
> 
> diff --git a/board/ti/ks2_evm/board_k2g.c b/board/ti/ks2_evm/board_k2g.c
> index 40edbaa..a738dd2 100644
> --- a/board/ti/ks2_evm/board_k2g.c
> +++ b/board/ti/ks2_evm/board_k2g.c
> @@ -12,6 +12,7 @@
>  #include <asm/arch/psc_defs.h>
>  #include <asm/arch/mmc_host_def.h>
>  #include "mux-k2g.h"
> +#include "../common/board_detect.h"
>  
>  #define SYS_CLK		24000000
>  
> @@ -149,6 +150,24 @@ int board_early_init_f(void)
>  }
>  #endif
>  
> +#ifdef CONFIG_BOARD_LATE_INIT
> +int board_late_init(void)
> +{
> +#if !defined(CONFIG_SPL_BUILD) && defined(CONFIG_TI_I2C_BOARD_DETECT)

You might want to select CONFIG_TI_I2C_BOARD_DETECT and
CONFIG_BOARD_LATE_INIT for this to take effect. I do not see these
configs enabled or am I missing something?

Thanks and regards,
Lokesh

> +	int rc;
> +
> +	rc = ti_i2c_eeprom_am_get(CONFIG_EEPROM_BUS_ADDRESS,
> +			CONFIG_EEPROM_CHIP_ADDRESS);
> +	if (rc)
> +		printf("ti_i2c_eeprom_init failed %d\n", rc);
> +
> +	board_ti_set_ethaddr(1);
> +#endif
> +
> +	return 0;
> +}
> +#endif
> +
>  #ifdef CONFIG_SPL_BUILD
>  void spl_init_keystone_plls(void)
>  {
>