Björn Steinbrink wrote:
> All kernels were bad using that approach. So back to square 1. :/
> 
> Björn
> 

OK guys, here's a new patch to try against 2.6.20-rc5:

Right now when switching between ADMA mode and legacy mode (i.e. when 
going from doing normal DMA reads/writes to doing a FLUSH CACHE) we just 
set the ADMA GO register bit appropriately and continue with no delay. 
It looks like in some cases the controller doesn't respond to this 
immediately, it takes some nanoseconds for the controller's status 
registers to reflect the change that was made. It's possible that if we 
were trying to issue commands during this time, the controller might not 
react properly. This patch adds some code to wait for the status 
register to change to the state we asked for before continuing.

-- 
Robert Hancock      Saskatoon, SK, Canada
To email, remove "nospam" from hancockr@nospamshaw.ca
Home Page: http://www.roberthancock.com/