Pavel Hofman schreef: > Alex Betis napsal(a): > >> On Wed, Dec 3, 2008 at 9:32 AM, Alex Betis > > wrote: >> >> >> On Wed, Dec 3, 2008 at 12:31 AM, Pavel Hofman >> > wrote: >> >> pavel@htpc:~/project/satelit2/szap-s2$ >> ./szap-s2 -x >> EinsFestival >> reading channels from file '/home/pavel/.szap/channels.conf' >> zapping to 5 'EinsFestival': >> delivery DVB-S, modulation QPSK >> sat 0, frequency 12110 MHz H, symbolrate 27500000, coderate auto, >> >> I don't think there is 12110 channel on Astra 19.2, at least not >> accirding to lyngsat. >> >> My bad, there is such channel... I somehow got to Astra 1G only page >> instead of all Atras in that position. >> Try other frequencies anyway. >> >> Maybe you have diseqc problems? >> >> > > Alex, > > Thanks a lot for your help. I tested the card on a different computer > with Windows and I could scan and view both Astra 19.2E and Astra 23.5E > free-to-air programs through A and B parts of the dual LNB. I have no > decoding card yet, nor any adapter. > > Since the computer was different, I will test my final computer/setup in > windows (just have to install them first here :) ). Nevertheless I think > it will work in windows. > > I will get back with result. > > Regards, > > Pavel. > > _______________________________________________ > linux-dvb mailing list > linux-dvb@linuxtv.org > http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb > Alex, I have the following problem. I'm not able to rotate my rotor with my HD2 card and any of the drivers (liplianin, v4l-dvb, Manu). I tried GotoX diseqc commands as well as the goto position used by scan-s2. As Pavel also has problems with diseqc (switch with A B input) I think it is not in the scan-s2 an szap-s2 utilities but in the driver. I changed the subject because I do not know if Pavels problem is only due to diseqc problems. I have another card (twinhan vp-1034 mantis) which should be able to rotate my rotor and I will try it next weekend to see if my rotor is not broken and I will also have a look into the driver but this will be not easy beacuse I do not have schematics or any documentation. Regards, Michel.