From mboxrd@z Thu Jan 1 00:00:00 1970 From: Igor Grinberg Date: Wed, 24 Aug 2011 15:31:51 +0300 Subject: [U-Boot] [PATCH 1/9] OMAP3: CM-T35: Use generic MMC driver In-Reply-To: <1314051236-21740-2-git-send-email-trini@ti.com> References: <1314051236-21740-1-git-send-email-trini@ti.com> <1314051236-21740-2-git-send-email-trini@ti.com> Message-ID: <4E54EF37.3060209@compulab.co.il> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On 08/23/11 01:13, Tom Rini wrote: > Switch from the legacy omap3 mmc driver to the new generic omap hsmmc > driver. This patch is based on the work done for Beagle, etc. > > Signed-off-by: Tom Rini It is a good practice to CC the board maintainer. Thanks. Tested-by: Igor Grinberg > --- > board/cm_t35/cm_t35.c | 8 ++++++++ > include/configs/cm_t35.h | 3 ++- > 2 files changed, 10 insertions(+), 1 deletions(-) > > diff --git a/board/cm_t35/cm_t35.c b/board/cm_t35/cm_t35.c > index f82111b..420cd70 100644 > --- a/board/cm_t35/cm_t35.c > +++ b/board/cm_t35/cm_t35.c > @@ -313,6 +313,14 @@ void set_muxconf_regs(void) > cm_t3730_set_muxconf(); > } > > +#ifdef CONFIG_GENERIC_MMC > +int board_mmc_init(bd_t *bis) > +{ > + omap_mmc_init(0); > + return 0; > +} > +#endif > + > /* > * Routine: setup_net_chip_gmpc > * Description: Setting up the configuration GPMC registers specific to the > diff --git a/include/configs/cm_t35.h b/include/configs/cm_t35.h > index 16a5f5b..496a904 100644 > --- a/include/configs/cm_t35.h > +++ b/include/configs/cm_t35.h > @@ -108,8 +108,9 @@ > #define CONFIG_BAUDRATE 115200 > #define CONFIG_SYS_BAUDRATE_TABLE {4800, 9600, 19200, 38400, 57600,\ > 115200} > +#define CONFIG_GENERIC_MMC 1 > #define CONFIG_MMC 1 > -#define CONFIG_OMAP3_MMC 1 > +#define CONFIG_OMAP_HSMMC 1 > #define CONFIG_DOS_PARTITION 1 > > /* DDR - I use Micron DDR */ -- Regards, Igor.