From mboxrd@z Thu Jan 1 00:00:00 1970 From: Heiko Schocher Date: Tue, 15 May 2012 09:19:37 +0200 Subject: [U-Boot] [PATCH] arm,davinci: update for enbw_cmc board In-Reply-To: <20120514173257.GE10008@bill-the-cat> References: <1336199570-22151-1-git-send-email-hs@denx.de> <20120514164558.GB10008@bill-the-cat> <20120514173257.GE10008@bill-the-cat> Message-ID: <4FB20389.6000808@denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Hello Tom, Tom Rini wrote: > On Mon, May 14, 2012 at 09:45:58AM -0700, Tom Rini wrote: >> On Sat, May 05, 2012 at 08:32:50AM +0200, Heiko Schocher wrote: >> >>> - change gpio pin settings: >>> >>> - gpio pin 6[13] (PLC reset) default value low >>> - gpio pin 6[0] (TPM reset) default value low >>> - 4 new GPIO pins >>> pin i/o name >>> - 3[9] input Board Type >>> - 2[7] input HW-ID0 >>> - 2[6] input HW-ID1 >>> - 2[3] input HW-ID2 >>> >>> - read board type and hw id from gpio pins on the enbw_cmc board, >>> and use board type for setting up different gpio pin settings. >>> >>> - do not pass "davinci_mmc.use_dma=0" to linux, as MMC now >>> works with DMA. >>> >>> - update logbuf support: >>> store post word in RTC scratch register >>> >>> - add support for configuring KSZ8864RMN switch through >>> a config file on u-boot startup. For more infos see: >>> doc/README.switch_config >>> >>> Signed-off-by: Heiko Schocher >>> Cc: Wolfgang Denk >>> Cc: Tom Rini >>> Cc: Christian Riesch >>> Cc: Sandeep Paulraj >> Applied to u-boot-ti/master, thanks. > > I take that back, sorry. With ELDK4.1 toolchain: > Configuring for enbw_cmc board... > enbw_cmc.c: In function 'enbw_cmc_getvalue': > enbw_cmc.c:447: warning: dereferencing type-punned pointer will break strict-aliasing rules > text data bss dec hex filename > 429329 8436 262084 699849 aadc9 eldk42/u-boot Ups, sorry! Only tested with ELDK-5.0/5.1 send v2 soon bye, Heiko -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de