On 05/21/2013 08:39 PM, Steven Rostedt wrote:
> On Fri, 2013-05-17 at 10:42 +0200, Stanislav Meduna wrote:
>> Hi all,
>>
>> I don't know whether this is linux-rt specific or applies to
>> the mainline too, so I'll repeat some things the linux-rt
>> readers already know.
>>
>> Environment:
>>
>> - Geode LX or Celeron M
>> - _not_ CONFIG_SMP
>> - linux 3.4 with realtime patches and full preempt configured
>> - an application consisting of several mostly RR-class threads
>
> The threads do a mlockall too right? I'm not sure mlock will lock memory
> for a new thread's stack.
>
>> - the application runs with mlockall()
>
> With both MCL_FUTURE and MCL_CURRENT set, right?
>
>> - there is no swap
>
> Hmm, doesn't mean that code can't be swapped out, as it is just mapped
> from the file it came from. But you'd think mlockall would prevent that.
>
>>
>> Problem:
>>
>> - after several hours to 1-2 weeks some of the threads start to loop
>>    in the following way
>>
>>    0d...0 62811.755382: function:  do_page_fault
>>    0....0 62811.755386: function:     handle_mm_fault
>>    0....0 62811.755389: function:        handle_pte_fault
>>    0d...0 62811.755394: function:  do_page_fault
>>    0....0 62811.755396: function:     handle_mm_fault
>>    0....0 62811.755398: function:        handle_pte_fault
>>    0d...0 62811.755402: function:  do_page_fault
>>    0....0 62811.755404: function:     handle_mm_fault
>>    0....0 62811.755406: function:        handle_pte_fault
>>
>>    and stay in the loop until the RT throttling gets activated.
>>    One of the faulting addresses was in code (after returning
>>    from a syscall), a second one in stack (inside put_user right
>>    before a syscall ends), both were surely mapped.
>>
>> - After RT throttler activates it somehow magically fixes itself,
>>    probably (not verified) because another _process_ gets scheduled.
>>    When throttled the RR and FF threads are not allowed to run for
>>    a while (20 ms in my configuration). The livelocks lasts around
>>    1-3 seconds, and there is a SCHED_OTHER process that runs each
>>    2 seconds.
>
> Hmm, if there was a missed TLB flush, and we are faulting due to a bad
> TLB table, and it goes into an infinite faulting loop, the only thing
> that will stop it is the RT throttle. Then a new task gets scheduled,
> and we flush the TLB and everything is fine again.

That sounds like maybe we DO want a TLB flush on spurious
page faults, so we get rid of this problem.

Last fall we thought this problem could not happen on x86,
but your bug report suggests that it might.

We can get flush_tlb_fix_spurious_fault to do a local TLB
invalidate of just the address in question by removing the
x86-specific dummy version, falling back to the asm-generic
version that does something.

Can you test the attached patch?

-- 
All rights reversed