On 13/02/14 09:17, Antonio Quartulli wrote:
> On 11/02/14 13:48, Antonio Quartulli wrote:
>> @@ -297,6 +299,7 @@ void batadv_update_min_mtu(struct net_device *soft_iface)
>>  static void
>>  batadv_hardif_activate_interface(struct batadv_hard_iface *hard_iface)
>>  {
>> +	struct net_device *dev = hard_iface->net_dev;
>>  	struct batadv_priv *bat_priv;
>>  	struct batadv_hard_iface *primary_if = NULL;
>>  
>> @@ -315,6 +318,22 @@ batadv_hardif_activate_interface(struct batadv_hard_iface *hard_iface)
>>  	if (!primary_if)
>>  		batadv_primary_if_select(bat_priv, hard_iface);
>>  
>> +	/* set the default values */
>> +	hard_iface->bat_v.flags &= ~BATADV_FULL_DUPLEX;
>> +	hard_iface->bat_v.eth_throughput = 0;
>> +	if (dev->phydev) {
>> +		if (dev->phydev->duplex == DUPLEX_FULL)
>> +			hard_iface->bat_v.flags |= BATADV_FULL_DUPLEX;
>> +
>> +		/* set the speed according to the phydev setting. Store the
>> +		 * value in Kbps (as done for the other throughput variables)
>> +		 */

And of course this is not Kbps but Mbps/10 (like everywhere else)..


>> +		if (dev->phydev->speed != SPEED_UNKNOWN) {
>> +			hard_iface->bat_v.eth_throughput = dev->phydev->speed;
>> +			hard_iface->bat_v.eth_throughput *= 10;
>> +		}
>> +	}
>> +
> 
> For the record: I just moved this chunk into a proper
> bat_algo_ops->bat_iface_activate() API.
> 
> This initialisation is obviously B.A.T.M.A.N. V specific and cannot live
> in the batadv_hardif_activate_interface() function.
> 
> 
> Cheers,
> 
> 


-- 
Antonio Quartulli